Delphi Suspension Stabilizer Bar Link Kit P/N:TC933
$26.99
(You save)
Keep the front stabilizer bar connected to the suspension and tame body roll with the Delphi Suspension Stabilizer Bar Link Kit (P/N: TC933). This front sway bar link kit drops in as a direct-fit replacement for the 2002-2005 Land Rover Freelander — see the Buyer's Guide tab for full engine-level fitment. A sway bar link ties the stabilizer bar to the control arm or strut; worn or broken links can cause clunking or rattling over uneven pavement and looser handling through turns, and this kit replaces the failed front link if that link is the cause.
Fatigue tested: Delphi sway bar links are fatigue tested to help avoid failure in service.
Ultrasonic molding: manufactured with ultrasonic molding to help prevent future weld breakage.
Micron tolerances: machined to micron tolerances for durability and smooth joint operation.
Anti-corrosion protection: applied to each part for corrosion prevention and enhanced aesthetics.
Delphi applies its OE expertise across its aftermarket steering portfolio, testing parts below -40°C and above 120°C and exposing them to 720 hours of salt spray, with dimensional and material analysis for compatibility between the OE and aftermarket part.
What is a stabilizer bar link kit and what does it do?
It connects the front stabilizer (sway) bar to the suspension, transferring load between the two sides so the bar can resist body roll. When a link wears or breaks, that connection is lost.
Does this kit fit my vehicle?
The TC933 kit is a direct-fit replacement for the 2002-2005 Land Rover Freelander. Check the Buyer's Guide tab for full engine-level fitment before ordering.
What are the signs my sway bar links may need replacing?
Common signs include clunking or rattling over bumps and uneven pavement, plus looser handling through turns. Have the cause diagnosed, since other suspension parts can produce similar symptoms.
Is this link a front or rear part?
This is a front stabilizer bar link kit for the listed Land Rover Freelander applications.
How is this Delphi link built for durability?
It is fatigue tested, made with ultrasonic molding to help prevent weld breakage, machined to micron tolerances for smooth joint operation, and treated with anti-corrosion protection.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Link Kit P/N:TC933
Keep body lean in check and quiet the clunks with the Delphi Rear Suspension Stabilizer Bar Link Kit (TC2616) — a direct-fit replacement for the 2002-2007 Mitsubishi Lancer (see the Buyer's Guide tab...
Tie the stabilizer bar back to the suspension and quiet front-end rattle with the Delphi Suspension Stabilizer Bar Link Kit TC2909. This front right sway bar link installs as a direct-fit replacement...
Tighten up front-end response and quiet the clunks with the Delphi Suspension Stabilizer Bar Link Kit TC6165. These front sway bar links connect the stabilizer bar to the suspension, transferring...
Quiet the clunks and keep the rear stabilizer bar tied to the suspension with the Delphi Suspension Stabilizer Bar Link Kit TC6526. This rear-position stabilizer bar link kit drops in as a direct-fit...
Keep body roll in check and quiet the rattles with the Delphi Front Suspension Stabilizer Bar Link Kit TC6540. This front sway bar link connects the stabilizer bar to the suspension so the bar can...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
