DENSO Auto Parts Alternator P/N:210-1110
DENSO Auto Parts 210-4302 alternator for the 2011-2013 Chrysler 200 4-cylinder 2.4L and other vehicles is a remanufactured unit that charges the battery. It is designed to meet the heat and electrical demands of contemporary cars with many electronic systems.
A battery warning light, dim headlights or a whining noise from the front of the engine can mean an alternator is wearing out. Before you replace it, look over the drive belt and the battery terminals with the engine off, since a glazed belt or a corroded terminal can leave the battery low even when the alternator is fine.
It fits the 2011-2013 Chrysler 200 4-cylinder 2.4L, and it is also an alternator for the 2007-2017 Jeep Patriot 4-cylinder 2.0L or 2.4L and the 2007-2017 Jeep Compass 4-cylinder 2.0L or 2.4L.
This listing holds one alternator, and the car needs just one.
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this Chrysler 200 alternator right for a 2011-2013 car with the 4-cylinder 2.4L?
Yes. DENSO Auto Parts 210-4302 fits the 2011-2013 Chrysler 200 4-cylinder 2.4L, and each car takes one alternator.
Does the DENSO 210-4302 work as a Jeep Compass alternator replacement for 2007-2017 cars with the 4-cylinder 2.0L or 2.4L?
Yes, DENSO Auto Parts 210-4302 fits the 2007-2017 Jeep Compass 4-cylinder 2.0L or 2.4L. For a car not named here, look yours up in the "Vehicles it fits" section on this page.
What voltage tests does this remanufactured DENSO alternator go through?
Stators and rectifiers are tested to 300 volts, and rotors to 600 volts. Rotor slip rings are buffed to an 8 micron finish with runout limited to 20 microns.
Which signs can mean an alternator is wearing out before I swap in the 210-4302?
Dim headlights, a battery warning light or a whine from the engine bay can be signs of a worn alternator, though other faults can cause them too. A shop can run a charging test, which needs the engine running.
Does the DENSO 210-4302 mount without belt or pulley alignment trouble?
Yes, the DENSO First Time Fit design is meant to mount with no belt or pulley alignment issues and a minimum of installation problems.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.