DENSO Auto Parts Oxygen Sensor P/N:234-4540
DENSO Auto Parts 234-3002 oxygen sensor for the 1987-1989 Ford F-150 6-cylinder 4.9L, the 1990 F-150 V8 5.0L and other vehicles reads the oxygen level in the exhaust for the engine computer. This DENSO Auto Parts oxygen sensor goes in the upstream position, where its signal helps the computer manage the air-fuel ratio.
A rough idle, poor fuel economy or a check engine light can mean the sensor is worn, though an exhaust leak or a faulty fuel injector can be behind them too, so find the cause first.
This direct-fit sensor also covers the 1987-1990 Ford Mustang 4-cylinder 2.3L, the 1987-1993 Mustang V8 5.0L, the 1987-1989 Ford F-250 6-cylinder 4.9L and the 1990 F-250 V8 5.0L. Those engines take one sensor each, and this listing is a single upstream sensor. If your car is not named here, look up your year, model and engine in the "Vehicles it fits" section.
Fit and size
Build and materials
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this a Ford F-150 oxygen sensor for the 1987-1989 6-cylinder 4.9L or the 1990 V8 5.0L?
Yes. DENSO Auto Parts 234-3002 fits the 1987-1989 Ford F-150 6-cylinder 4.9L and the 1990 F-150 V8 5.0L, one upstream sensor each. If your vehicle is a different model, look it up in the "Vehicles it fits" section.
Does this work as a Ford Mustang oxygen sensor for the 1987-1990 4-cylinder 2.3L or the 1987-1993 V8 5.0L?
Yes. DENSO Auto Parts 234-3002 fits the 1987-1990 Ford Mustang 4-cylinder 2.3L and the 1987-1993 Mustang V8 5.0L, and each takes one sensor.
What thread size and harness length does the DENSO 234-3002 have?
The thread diameter is 0.708 in and the wiring harness is 10.94 in long. It is a heated, narrow-band, three-wire sensor with a male connector.
What signs can point to a worn upstream oxygen sensor like this one?
Poor fuel economy, a rough idle or a check engine light can be signs. A shop can test the sensor with the engine running to confirm.
What do the PTFE filter and aluminum oxide trap layer do in this DENSO oxygen sensor?
The PTFE filter blocks contaminants, and the aluminum oxide trap layer protects the ceramic element from silicone and lead poisoning.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.