DENSO Auto Parts Oxygen Sensor P/N:234-4642
DENSO Auto Parts 234-4066 oxygen sensor for the 2006-2011 Chevrolet HHR 4-cylinder 2.2L or 2.4L and other vehicles senses the oxygen left in the exhaust after the catalytic converter. This downstream sensor is a direct-fit part, built and tested to OE standards.
A worn oxygen sensor can show up as a check engine light, lower fuel economy or a failed emissions test. Before you replace the sensor, rule out a damaged wiring harness or an exhaust leak near it, since either can set off a similar warning light; a shop can scan the codes to tell them apart.
This downstream oxygen sensor also fits the 2005-2007 Chevrolet Cobalt 4-cylinder 2.0L, the 2005-2010 Cobalt 4-cylinder 2.2L and the 2006-2008 Cobalt 4-cylinder 2.4L. It is the oxygen sensor for the 2007-2008 Pontiac G5 4-cylinder 2.4L and the 2007-2010 G5 4-cylinder 2.2L too, and every car named here needs a single sensor, which is what this listing holds.
Fit and size
Build and materials
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Does this Chevy Cobalt oxygen sensor fit the 2005-2007 Cobalt 4-cylinder 2.0L, the 2005-2010 Cobalt 4-cylinder 2.2L and the 2006-2008 Cobalt 4-cylinder 2.4L?
Yes, DENSO Auto Parts 234-4066 fits those years and engines, one sensor per car. If your car is a different model, look for it in the "Vehicles it fits" section.
Is this a Chevy HHR oxygen sensor for the 2006-2011 HHR 4-cylinder 2.2L or 2.4L?
Yes. DENSO Auto Parts 234-4066 is the downstream sensor for the 2006-2011 Chevrolet HHR 4-cylinder 2.2L or 2.4L, which takes one.
Is this oxygen sensor upstream or downstream?
This oxygen sensor is a downstream unit, the position behind the catalytic converter. It is not the upstream sensor.
How long is the wire on this 4-wire oxygen sensor?
The wiring harness is 27.95 inches long and ends in a female connector. The threaded body has a thread diameter of 0.708 inch.
What does the aluminum oxide trap layer on this oxygen sensor do?
The aluminum oxide trap layer is designed to protect the ceramic element from silicone and lead poisoning.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.