DENSO Auto Parts Oxygen Sensor P/N:234-4642
DENSO Auto Parts 234-4105 oxygen sensor for the 2002-2003 Suzuki Aerio 4-cylinder 2.0L, the 2004-2007 Aerio 4-cylinder 2.3L and other vehicles measures the oxygen left in the exhaust so the engine computer can adjust fuel delivery. This upstream, heated, narrow-band sensor is a direct-fit part, manufactured and tested to the strictest OE standards.
A tired oxygen sensor can show up as a check engine light, a rough idle or poorer fuel economy. Before you replace the sensor, rule out a damaged wire or connector and an exhaust leak ahead of it, since those can produce readings that look the same.
The 2002-2003 Suzuki Aerio 4-cylinder 2.0L, the 2004-2007 Aerio 4-cylinder 2.3L, the 1999-2005 Suzuki Grand Vitara V6 2.5L and the 2001-2004 Chevrolet Tracker V6 2.5L all take it, along with more vehicles. Driving something else? Look up your year, make and engine in the "Vehicles it fits" section.
Fit and size
Build and materials
One oxygen sensor. The 2002-2003 Suzuki Aerio 4-cylinder 2.0L takes one, while the 1999-2005 Suzuki Grand Vitara V6 2.5L and the 2001-2004 Chevrolet Tracker V6 2.5L take two.
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this DENSO Auto Parts oxygen sensor heated or unheated?
It is heated. DENSO Auto Parts 234-4105 is a heated, narrow-band oxygen sensor with 4 wires and a male connector.
Is this the Suzuki Aerio oxygen sensor for a 2002-2003 car with the 4-cylinder 2.0L or a 2004-2007 car with the 4-cylinder 2.3L?
Yes. DENSO Auto Parts 234-4105 fits both, and each takes one sensor. For other cars, look up your year, make and engine in the Vehicles it fits section.
Is this a Chevy Tracker oxygen sensor for the 2001-2004 model with the V6 2.5L?
Yes. It fits the 2001-2004 Chevrolet Tracker V6 2.5L, which takes two sensors; this listing is one.
How long is the wire on this oxygen sensor and what thread does it have?
The wiring harness is 13.39 in long and the thread diameter is 0.708 in. The sensor mounts by threading into place.
What protects the ceramic element in this oxygen sensor from contamination?
A PTFE filter blocks contaminants, and an aluminum oxide trap layer is designed to protect the element from silicone and lead poisoning. The housing is laser-welded stainless.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.