DENSO Auto Parts Oxygen Sensor P/N:234-2052
DENSO Auto Parts 234-4116 oxygen sensor for the 2014-2020 Mitsubishi Outlander 4-cylinder 2.4L and other vehicles reads the oxygen left in the exhaust for the engine computer. Its heated narrow-band element helps the computer keep the air-fuel ratio in range.
A worn oxygen sensor can show up as a check engine light, poorer fuel economy or a rough idle, and each of those can have other causes. With the engine off and cool, look over the sensor wiring and connector for cracks, melted insulation or damage before you decide on a replacement.
This direct-fit oxygen sensor fits the 2014-2020 Mitsubishi Outlander 4-cylinder 2.4L, the 2008-2015 Mitsubishi Lancer 4-cylinder 2.0L and the 2009-2013 Lancer 4-cylinder 2.4L, and the 2018-2020 Mitsubishi Eclipse Cross 4-cylinder 1.5L. If your car is not named here, open the "Vehicles it fits" section to check your exact model and engine.
Fit and size
Build and materials
One oxygen sensor. The listing holds one sensor, and the fitment lists a quantity of one.
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this a Mitsubishi Outlander oxygen sensor for the 2014-2020 model with the 4-cylinder 2.4L?
Yes. DENSO Auto Parts 234-4116 is listed for the 2014-2020 Mitsubishi Outlander 4-cylinder 2.4L. Open the "Vehicles it fits" section to check other years and engines.
Does this work as a Lancer oxygen sensor on the 2009-2013 Mitsubishi Lancer 4-cylinder 2.4L?
Yes. This sensor is listed for the 2009-2013 Mitsubishi Lancer 4-cylinder 2.4L, and the 2008-2015 Lancer 4-cylinder 2.0L takes it too. The fitment lists a quantity of one.
Is this DENSO Auto Parts oxygen sensor heated, and how many wires does it have?
Yes. DENSO 234-4116 is a heated narrow-band sensor with 4 wires and a female connector.
What protects the ceramic element in this oxygen sensor?
An aluminum oxide trap layer protects the ceramic element from silicone and lead poisoning. A dual-layer shield also protects the element, and a PTFE filter blocks contaminants.
How long is the wiring harness on this oxygen sensor?
The harness is 36.10 in long. The sensor mounts by thread and has a thread diameter of 0.708 in.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.