DENSO Auto Parts Oxygen Sensor P/N:234-8084
DENSO Auto Parts 234-4194 left oxygen sensor for the 2003-2006 Hyundai Santa Fe V6 3.5L, the 2007-2009 Santa Fe V6 2.7L and other vehicles measures the oxygen in the exhaust and reports it to the engine computer. This DENSO Auto Parts oxygen sensor is a heated, narrow-band unit made and tested to the strictest OE standards.
A lit check engine light, poorer fuel economy or a rough idle can go with a worn oxygen sensor. Those signs alone do not prove the sensor is the problem, since a vacuum leak can look much the same.
The same sensor is a direct-fit, threaded oxygen sensor for the 2003-2006 Kia Sorento V6 3.5L and the 2006-2010 Kia Optima V6 2.7L. If your car is not named here, open the "Vehicles it fits" section and match your exact model and engine against it.
Fit and size
Build and materials
One oxygen sensor. The quantity per car depends on the engine: the 2007-2009 Hyundai Santa Fe V6 2.7L takes one, the 2003-2006 Santa Fe V6 3.5L takes two, and the Kia models above take two.
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is DENSO 234-4194 an oxygen sensor for the 2003-2006 Hyundai Santa Fe V6 3.5L?
Yes, DENSO Auto Parts 234-4194 fits the 2003-2006 Hyundai Santa Fe V6 3.5L and the 2007-2009 Santa Fe V6 2.7L; for another car, open the "Vehicles it fits" section and match your model and engine.
Is this an oxygen sensor replacement for the 2007-2009 Hyundai Santa Fe V6 2.7L, and how many does it take?
Yes, this listing is one sensor, and the 2007-2009 Hyundai Santa Fe V6 2.7L takes one while the 2003-2006 Hyundai Santa Fe V6 3.5L takes two.
What are the thread diameter and harness length on this 4-wire oxygen sensor?
DENSO 234-4194 screws in with a 0.708 in thread diameter. It has a 16.93 in wiring harness with four wires and a male connector.
What can a failing heated oxygen sensor look like?
A check engine light, poorer fuel economy or a rough idle can go with a worn sensor. A shop can read the stored codes to see which sensor is reporting a fault.
What does the aluminum oxide trap layer in this oxygen sensor do?
That layer is designed to keep silicone and lead from poisoning the ceramic element. A PTFE filter and dual-layer protection add to that under harsh engine conditions.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.