DENSO Auto Parts Oxygen Sensor P/N:234-4606
DENSO Auto Parts 234-4550 oxygen sensor for the 2011-2014 Hyundai Elantra 4-cylinder 1.8L, the 2014 Elantra 4-cylinder 2.0L and other vehicles reads the oxygen level in the exhaust after the catalytic converter and sends it to the engine computer. Each unit is built and tested to OE standards as a direct-fit replacement.
A check engine light, lower fuel economy or a rough idle can mean an oxygen sensor is wearing out, but those signs have other sources too. With the engine off and cool, look over the sensor's wiring and connector for cracks, chafing or melted insulation before you replace it.
This downstream sensor is a direct-fit replacement for the 2011-2014 Hyundai Elantra 4-cylinder 1.8L, the 2014 Elantra 4-cylinder 2.0L, the 2013 Hyundai Elantra Coupe 4-cylinder 1.8L, the 2014 Elantra Coupe 4-cylinder 2.0L, the 2013 Hyundai Elantra GT 4-cylinder 1.8L and the 2014 Elantra GT 4-cylinder 2.0L.
Fit and size
Build and materials
One oxygen sensor. This listing holds one sensor, and the downstream position on these vehicles takes one.
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this the 2013 Hyundai Elantra 4-cylinder 1.8L oxygen sensor?
Yes. DENSO Auto Parts 234-4550 is listed for the 2013 Hyundai Elantra 4-cylinder 1.8L as the downstream sensor, and the car takes one.
What thread size does this DENSO Auto Parts oxygen sensor have?
DENSO Auto Parts 234-4550 has a threaded mount with a 0.708 in thread diameter. It has four wires and a 29.09 in wiring harness with a female connector.
Is this downstream oxygen sensor heated?
Yes. This sensor is a heated, narrow-band type with four wires, and it is listed for the downstream position.
How can I tell if this downstream oxygen sensor is wearing out?
A check engine light, poorer fuel economy or a rough idle can point to a worn sensor. A shop can read the codes and test it while the engine runs.
What protects the ceramic element in this oxygen sensor from silicone and lead?
An aluminum oxide trap layer is designed to protect the ceramic element from silicone and lead poisoning. A PTFE filter also blocks contaminants.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.