Dorman - Autograde Wheel Lug Nut P/N:611-280
If the factory lug nuts on your car have started to swell, bulge or seize, this Dorman wheel lug nut, part number 611-084, is a one-piece replacement with an M12-1.50 thread and a dome top, designed to avoid the problems of two-piece factory nuts. It fits many vehicles, among them the 2018-2021 Chevrolet Equinox, 2008-2013 Chevrolet Impala and 2004-2012 Chevrolet Malibu, and is cataloged for both front and rear wheel positions. See the "Vehicles it fits" section for the full list.
On certain vehicles, the original lug nuts use a two-piece design that is prone to failure. A thin outer veneer can be damaged with repeated use. If moisture gets under it, the cover can bulge, which makes the nut hard or impossible to remove, and freeing a stuck nut often damages the wheel. This Dorman OE FIX replacement is built to match the original nut's fit and function. Its one-piece carbon steel construction is designed to prevent the same failures from happening again.
Specifications: M12-1.50 thread, dome top, 19 mm hex, 36 mm length.
Interchange: 559-190
559190 · C21966 · B142213 · 10018202 · 14032479 · 88891748 · 9591699 · 9591701 · 9594682 · 9598708 · 8095946820 · 92543 · 98051 · 9982N · RB9982N · 09594682 · BD61300
This part cross-references / interchanges with the following part numbers:
How are the Dorman autograde lug nuts different from two-piece factory nuts?
This nut has a one-piece carbon steel design with no thin veneer cover. With no cover, moisture has nothing to get under, so it cannot bulge the cap, which is a common cause of stuck two-piece nuts.
What are the specs of this Dorman wheel nut?
It has an M12-1.50 thread, a dome top, a 19 mm hex and an overall length of 36 mm.
Does it fit the 2018-2021 Chevrolet Equinox, 2008-2013 Chevrolet Impala and 2004-2012 Chevrolet Malibu?
It is listed for the 2018-2021 Chevrolet Equinox, 2008-2013 Chevrolet Impala and 2004-2012 Chevrolet Malibu, along with many other vehicles. Check the "Vehicles it fits" section to confirm yours.
What are signs a lug nut may need replacing?
Signs include a swollen or bulging cap, a socket that no longer fits the hex, rounded corners, or damaged threads.
How should this lug nut be installed?
Start it on the stud by hand. Then tighten it in a crisscross pattern to the torque value in your vehicle's service information. It is cataloged for both front and rear wheel positions.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.