Swap out a swollen, hard-to-remove factory lug nut with the Dorman wheel lug nut, part number 611-263, a one-piece, carbon steel flattop nut built as a Dorman OE FIX for a failure-prone two-piece original. It fits many vehicles, among them the 2005-2009 Chevrolet Equinox, 2016-2025 Chevrolet Malibu and 2006-2009 Chevrolet Impala, at both front and rear wheel positions. See the Buyer's Guide tab for the full list.
On certain vehicles, the original lug nuts use a two-piece design with a thin veneer cover. Repeated use can damage that veneer, and moisture that gets underneath can make the cover bulge. The nut can then be difficult or impossible to remove, and removing a stuck nut usually means damaging the wheel. This Dorman Autograde wheel lug nut is designed to match the original's fit and function. It uses a single piece of carbon steel in place of that construction, intended to help keep the same problem from happening again.
- Improved design: a direct-replacement, one-piece lug nut instead of the two-piece factory design that often leads to premature wheel nut failure.
- Corrosion resistant: the original design's veneer is removed, so there is no cover for moisture and rust to get under and bulge.
- Thoroughly tested: put through proof load, salt spray, hardness and thread check testing to meet strict standards.
- Quality engineering: designed in the United States and backed by decades of automotive aftermarket experience.
Specifications: This Dorman wheel nut has an M12-1.50 thread, a flattop style, a 19mm hex and a 35.9mm length.
Interchange: 9596863 · 9599297
