Dorman - Autograde Wheel Lug Stud P/N:610-455
Give a worn or damaged wheel mounting point a fresh anchor with the Dorman wheel lug stud 610-219, a 1/2-20 serrated stud from the Autograde line with a .625 in. knurl and a 2 in. length. It fits many vehicles, among them the 1976-1996 Ford F-150, 1976-1977 Ford F-250 and 1965-1967 Ford Mustang. It is a direct-fit replacement for the listed applications in both front and rear positions. See the "Vehicles it fits" section for the full list.
These lug studs are made of carbon steel and tested to demanding automotive industry standards for strength, longevity and safety.
The serrated knurl presses into the wheel mounting flange and holds the stud in place while the lug nut clamps the wheel. A stud may need replacing if its threads are stripped or damaged, if it is bent or broken, or if the lug nut will not thread on or tighten properly. Follow the vehicle service information for the installation procedure and lug nut torque.
Interchange: 560-277
560277 · C5SZ1107A · C5ZZ1107A · C9TZ1107D · D2TZ1107A · D6TZ1107A · 399416 · 92493 · 97147 · 27878B · RB27878B · BD60918
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
What does a wheel lug stud do?
A wheel lug stud is a threaded stud set in the wheel mounting flange. The lug nut threads onto it to clamp the wheel in place.
What are the specs of Dorman 610-219?
It is a 1/2-20 serrated wheel stud with a .625 in. knurl and a 2 in. length. It is made of carbon steel that meets SAE standards for strength and hardness.
Does this Dorman lug stud fit the 1976-1996 Ford F-150?
Yes. It is listed for the 1976-1996 Ford F-150 in front and rear positions. It also fits the 1976-1977 Ford F-250 and the 1965-1967 Ford Mustang. See the "Vehicles it fits" section for other vehicles.
What are signs a wheel lug stud needs replacing?
Common signs are stripped or damaged threads, a bent or broken stud, or a lug nut that will not thread on or tighten properly.
How is this wheel stud installed?
The serrated knurl is pressed into the wheel mounting flange. Follow the vehicle service information for the installation procedure and the correct lug nut torque.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.