Dorman - First Stop Brake Hydraulic Hose P/N:H622712
Keep brake fluid moving to the front right wheel with this Dorman brake hydraulic hose, Dorman - First Stop part number H38740, a direct-fit replacement for the 1993-2001 Subaru Impreza and 1990-1999 Subaru Legacy. It is precision-engineered to perform like the original brake hose on these vehicles in the front right position, and is intended for use as part of a complete brake repair.
A brake hydraulic hose is the flexible link between the vehicle's rigid brake lines and the brake at the wheel. It carries pressurized brake fluid while the suspension and steering move. Cracked or bulging rubber, fluid seeping at the fittings, or a soft brake pedal are signs a hose may need replacing. Other brake parts can cause similar symptoms, so diagnose the system before you replace anything. Engine details for each application are listed in the "Vehicles it fits" section.
Interchange: 87-18013 · HB-55013 · 073-1277 · 150.47013 · 350-13012
8718013 · HB55013 · 0731277 · 15047013 · 35013012 · 18J732 · B917572 · 610760 · 77981 · BH252620 · BH38740 · 26531AA001 · 26531AA080 · 2203656 · BH123806 · F123806
This part cross-references / interchanges with the following part numbers:
Which Subaru models does this brake hose fit?
It is a direct-fit replacement for the front right position on the 1993-2001 Subaru Impreza and the 1990-1999 Subaru Legacy. Engine details are in the "Vehicles it fits" section.
Which position does the H38740 brake hose install in?
It installs in the front right position. The hose is position-specific and built to precise measurements for that location, for an exact fit and easy installation.
What is this brake hydraulic hose made of?
It is made with EPDM rubber and has specially coated fittings that resist corrosion. Its materials are tested to government-regulated safety and durability standards.
What are the signs a brake hydraulic hose may need replacing?
Signs include cracked, swollen or bulging rubber, fluid leaking at the fittings, or a soft or spongy brake pedal. Have the brake system diagnosed first, because other parts can cause similar symptoms.
Do I need to bleed the brakes after installing this hose?
Yes. Bleed the hydraulic system to remove air whenever a brake hose is replaced. Consult the vehicle service information for the correct fasteners and torque values, and whether any original hardware may be reused.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.