Dorman - First Stop Brake Hydraulic Hose P/N:H36669
Dorman H620357 rear left brake hydraulic hose for the 1997-2002 Chevrolet B7 and other vehicles carries brake fluid through a flexible section of the brake line. This Dorman brake hydraulic hose is made for the rear left position and is engineered to match the performance of the original brake hose on specific vehicles.
Fluid seepage at a fitting, cracked or bulging rubber, or a soft pedal can mean the hose is wearing out. These signs alone do not prove the hose is the problem, since a leaking caliper or wheel cylinder can leave a similar wet spot. Replace the pair together: this listing is one hose for the rear left, and the rear right is a separate part. Each wheel on the axle takes one.
The vehicles it fits also include the 1997-2002 Chevrolet C6500 Kodiak and the 1997-2002 Chevrolet C7500 Kodiak, plus several GMC models.
Fit and size
Build and materials
One brake hydraulic hose with its stamped steel bracket. Mounting hardware and a gasket or seal are not included, so plan on new fasteners; the old ones may not be reusable.
Interchange: 176-1245
BH417580 · 19256415 · 22163671 · BH381322 · 2204056 · BH140740 · F140740
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Does the Dorman H620357 hose fit the 1997-2002 Chevrolet B7?
Yes. Dorman H620357 is a rear left brake hydraulic hose for the 1997-2002 Chevrolet B7. If your vehicle is a different model, look it up in the "Vehicles it fits" section on this page.
Does this rear left brake hydraulic hose come with its bracket?
Yes. The box holds one hose with a stamped steel bracket. Mounting hardware and a gasket or seal are not included.
What are the end fittings on the Dorman H620357 brake hydraulic hose?
End 1 is a male fitting with a 7/16 in-24 thread. End 2 is a female fitting with a 7/16-24 inside diameter. Both fittings are treated steel.
Can I spot a failing rear brake hydraulic hose by looking at it?
Cracks, bulges or wet fluid on the rubber or at the fittings can point to a failing hose, and a soft pedal can go with it. A shop can pressure-test it, so have brake work done promptly.
Is the Dorman H620357 hose made of EPDM rubber?
Yes. The hose is EPDM rubber with a plastic outer sleeve. The end fittings are treated steel with a corrosion-resistant coating, and the hose is DOT approved.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.