Dorman - First Stop Brake Hydraulic Hose P/N:H621238
Carry pressurized brake fluid at the rear left outer position with this Dorman brake hydraulic hose from the First Stop line, part number H620781. It fits many vehicles, among them the 2008-2010 Chevrolet Silverado 2500, 2007-2013 Chevrolet Suburban 2500 and 2007-2013 GMC Yukon XL 2500, as a direct-fit replacement for the listed applications. See the "Vehicles it fits" section for the full list.
A brake hose is the flexible link in the hydraulic system. It carries fluid under pressure while allowing for suspension and axle movement. Dorman designed this hose to serve as one piece of a complete brake repair.
Signs a brake hose may need replacing include bulging, cracking, fluid seepage at the fittings, or a soft or spongy pedal. Diagnose the cause before you replace anything, because other brake components can produce similar symptoms. Bleed the brake system after installation. While the brakes are apart, it is good practice to inspect the other brake hoses as well.
Interchange: 176-1529 · 176-1676 · 176-1683 · 150.66374 · 350-47412
1761529 · 1761676 · 1761683 · 15066374 · 35047412 · 612821 · 10367834 · 10367836 · 15202429 · 15902879 · 25779543 · 25801591 · 25801596 · 25923712 · BH383263 · 2202932 · BH142784 · F142784
This part cross-references / interchanges with the following part numbers:
What does a brake hydraulic hose do?
It is the flexible section of the brake hydraulic circuit. At the rear left outer position it carries pressurized brake fluid while allowing for suspension and axle movement.
What is the Dorman H620781 made of?
Dorman states the hose is made with EPDM rubber and uses specially coated, corrosion-resistant fittings.
Does this brake hose fit a 2008-2010 Chevrolet Silverado 2500?
Yes. It is listed for the 2008-2010 Chevrolet Silverado 2500 at the rear left outer position. The "Vehicles it fits" section shows every listed vehicle.
What are signs this brake hose may need replacing?
Bulging, cracking, fluid seepage at the fittings, or a soft or spongy pedal can mean the hose needs replacing. Diagnose the cause first, because other brake parts can cause similar symptoms.
Is there anything to know about installation?
Bleed the brake system after installing the hose to remove air. Check the vehicle service information for torque values and for whether the original fasteners or washers can be reused.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.