Carry pressurized brake fluid from the hard line to the front-right caliper with the Dorman - First Stop Brake Hydraulic Hose H621099. This flexible hose is built to replace the original front-right brake line in the specified position, and it drops in as a direct-fit replacement for the 2009-2010 Pontiac Vibe, 2008-2018 Toyota Corolla, and 2008-2014 Toyota Matrix (all engines).
Durable design: EPDM rubber hose with a rubber outer sleeve and specially coated, corrosion-resistant treated-steel fittings.
Position-specific fittings: a banjo fitting on End 1 (10 mm thread) and a female fitting on End 2 (M10 x 1.0), with an overall length of 25 in.
Quality assured: DOT approved, with materials tested to government-regulated safety and durability standards.
In the box: one brake hose plus gasket(s) and a stamped steel bracket; mounting hardware is not included — consult the vehicle service information for the correct fasteners and whether they may be reused.
Over time a flexible brake hose can crack, chafe, bulge, or leak, and internal deterioration can cause a soft or spongy pedal. If a failed front-right hose is the cause, this hose replaces it. Country of origin: China.
Interchange: 612975 · 150.44149 · 350-76105 · 35076105 · 19184373 · BH383326 · 2202987 · 9094702E76 · 9094702G77 · 90947A2025 · 90947A2075 · 90947A2077 · BH143821 · F143821
This part cross-references / interchanges with the following part numbers:
Where does this hose install?
It is the front-right brake hydraulic hose, carrying pressurized brake fluid from the hard line to the front-right caliper on the listed applications.
What vehicles does it fit?
The 2009-2010 Pontiac Vibe, 2008-2018 Toyota Corolla, and 2008-2014 Toyota Matrix (all engines). Check the Buyer's Guide tab to confirm your vehicle.
What is it made of?
An EPDM rubber hose with a rubber outer sleeve and specially coated, corrosion-resistant treated-steel fittings. It is DOT approved and 25 in long.
What's included?
One brake hose, gasket(s), and a stamped steel bracket. Mounting hardware is not included; consult the service information for the correct fasteners and whether they may be reused.
What are the end fittings?
End 1 is a banjo fitting with a 10 mm thread; End 2 is a female fitting sized M10 x 1.0.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.