Route pressurized brake fluid to the rear brakes with the Dorman - First Stop Brake Hydraulic Hose H97659, a flexible EPDM rubber hose that carries hydraulic pressure from the steel line to the wheel while flexing with suspension and axle movement. It fits the rear, rear center position and drops in as a direct-fit replacement built to match the fit, function and performance of the original hose on the listed applications, including the 1976-1979 Dodge D100, 1977-1981 Dodge D150, 1974 Dodge M400, 1978-1981 Dodge Ramcharger and 1978-1981 Plymouth Trailduster (all engines) — see the "Vehicles it fits" section for the full list.
- Durable construction: made with EPDM rubber and specially coated, corrosion-resistant fittings.
- Position-specific: manufactured to precise measurements for an exact fit and easy installation.
- End fittings: End 1 junction fitting and End 2 threaded fitting (3/8 in-24), both treated steel; overall length 22.50 in.
- Quality assured: DOT approved and tested to government-regulated safety and durability standards.
Package contains 1 brake hose; no mounting hardware, bracket, jacket, or gasket/seal is included — consult the vehicle service information for the correct fasteners and whether they may be reused. Country of origin: China. Signs this hose may need replacing include cracking, bulging, or fluid seepage at the hose or fittings; if a failed hose is the cause, this replaces it.
Interchange: 18J218 · B916915 · 613241 · 88645 · 150.67303 · 4031299 · 4115556 · BH188645 · 350-40233 · 35040233 · NF5016 · 4538083 · BH38083 · 2203057 · BH97659 · F97659 · Manufacturer part number H97659
This part cross-references / interchanges with the following part numbers:
18J218, B916915, 613241, 88645, 150.67303, 4031299, 4115556, BH188645, 350-40233, NF5016, BH38083, 2203057, BH97659, F97659
Frequently Asked Questions
What does this brake hydraulic hose do?
It carries pressurized brake fluid from the rigid brake line to the rear brake while flexing with suspension and axle movement, maintaining the hydraulic connection needed for braking.
What position does it fit?
It is a position-specific hose for the rear, rear center location on the listed applications. Check the "Vehicles it fits" section to confirm it matches your vehicle.
What is it made of?
The hose is EPDM rubber with specially coated, corrosion-resistant fittings. End 1 is a junction fitting and End 2 is a threaded fitting (3/8 in-24); both fittings are treated steel.
Is it DOT approved?
Yes. It is DOT approved and its materials are tested to exacting government-regulated safety and durability standards.
What comes in the package?
One brake hose. No mounting hardware, bracket, jacket, or gasket/seal is included; consult the vehicle service information for the correct fasteners and whether they may be reused.
