Dorman - First Stop Brake Master Cylinder P/N:M118403
Replacing a worn G6 master cylinder? The Dorman First Stop Brake Master Cylinder M630443 converts pedal effort into hydraulic pressure for the brake circuits, and it is engineered with precision to replicate the original master cylinder's design, function and performance. It is a direct-fit replacement for the 2004-2008 Chevrolet Malibu (engine: All), the 2005-2006 Pontiac G6 (engine: All) and the 2007 Saturn Aura (engine: All).
Specifications: 2 outlets; 0.938 in bore diameter; rearward outlet size M10 x 1.0; secondary outlet thread diameter M10 x 1.0; primary outlet thread pitch 1 mm. The reservoir and sensor are included, and mounting hardware is not included. Country of origin: China.
Signs a master cylinder may need replacing include a soft or slowly sinking brake pedal, brake fluid seeping from the cylinder, a dropping fluid level or an illuminated brake warning light. These symptoms can have other causes, so diagnose the brake system first. If the master cylinder is at fault, this unit replaces it.
Interchange: 174-1008 · 100-2346 · 13-3124 · 10-3124 · 130.62133 · 131.62133 · 355-47092
1741008 · 1002346 · 133124 · 103124 · 13062133 · 13162133 · 35547092 · 22675995 · M4091 · NM4091 · MC390885 · F143117 · MC143117
This part cross-references / interchanges with the following part numbers:
Is this the right Pontiac G6 master cylinder for my car?
M630443 is listed for the 2004-2008 Chevrolet Malibu (engine: All), the 2005-2006 Pontiac G6 (engine: All) and the 2007 Saturn Aura (engine: All).
Does it come with a reservoir and sensor?
Yes, the reservoir and sensor are both included with the master cylinder, but mounting hardware is not.
What are the outlet and bore specifications?
It has 2 outlets and a 0.938 in bore diameter. The rearward outlet size and secondary outlet thread diameter are M10 x 1.0, and the primary outlet thread pitch is 1 mm.
What signs suggest a master cylinder may need replacing?
Common signs are a soft or sinking pedal, fluid seeping from the cylinder, a dropping fluid level or a brake warning light. Other faults can cause these, so diagnose before replacing.
Do I need to bleed the brakes after installing it?
Yes. Replacing a master cylinder generally involves bench bleeding the unit and then bleeding the brake system; follow your vehicle's service information for the correct procedure and brake fluid.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.