Dorman - First Stop Parking Brake Cable P/N:C660538
Dorman C661397 rear right parking brake cable for the 2008 Ford Escape and other vehicles carries the parking brake pull to the rear right brake. Setting the parking brake pulls on this cable, which applies the brake at that wheel.
A parking brake lever that travels farther than it used to, a vehicle that rolls on a slope with the brake set, or a rear brake that stays applied can mean the cable is stretched, rusted or frayed. Worn rear brake pads or shoes, or a stuck rear brake part, can be behind these signs too, so find the cause before buying.
It is a parking brake cable for the 2008 Ford Escape and the 2008 Mercury Mariner. It is engineered and tested to follow the fit, function and performance of the original cable. This listing is one cable for the rear right; the rear left is a separate part, and the two sides of that axle are normally done at the same time. The 2008 Ford Escape takes one for the rear right.
Fit and size
Build and materials
One parking brake cable with a mounting bracket. Mounting hardware is not included, so plan on new fasteners rather than reusing the old ones.
Interchange: 8M6Z2A635A · BC97319 · BC143832
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this Dorman parking brake cable the rear right one for the 2008 Ford Escape?
Yes. Dorman C661397 is the rear right cable for the 2008 Ford Escape and the 2008 Mercury Mariner. The rear left side is a separate part.
Does the Dorman brake cable come with a mounting bracket?
Yes, one mounting bracket comes with the cable. Mounting hardware is not included, so plan on new fasteners.
What ends and conduit length does the C661397 cable have?
Dorman C661397 has a barrel end and an eyelet end. The conduit is 26.45 in long and the jacket is 11 mm in diameter.
Can a loose parking brake lever mean the rear cable is worn?
It can. A lever with extra travel, a brake that will not hold on a slope, or a rear brake that stays applied can point to a worn or rusted cable.
Are the fittings on this parking brake cable zinc-plated?
Yes. The fittings are zinc-plated to prevent corrosion, and the flexible casings are covered with conduit to limit wear on the inner cables.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.