Dorman - OE Solutions Air Spring to Coil Spring Conversion Kit P/N:949-518
Dorman 949-587 front shock absorber conversion kit for the 2006-2011 Buick Lucerne and other vehicles replaces the electronic MagneRide front strut with a conventional strut. It suits older cars where keeping the original Magnetic Ride Control strut is no longer necessary.
A worn front strut can show up as extra bounce after bumps, nose-dive under braking or a knock over rough roads. Before you replace it, have a shop rule out a worn top mount, ball joint or control arm bushing, since any of these can also make the front end knock or feel loose. Both front struts are normally replaced as a pair, and this listing is one bare strut, sold individually.
This front shock absorber conversion kit is a direct-fit replacement for the 2006-2011 Buick Lucerne and the 2006-2011 Cadillac DTS.
Fit and size
Build and materials
One front shock absorber conversion kit, made up of a single bare front strut. The coil spring and top mount are not included.
Interchange: SK-2952
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Will the Dorman 949-587 replace the MagneRide front strut on a 2006-2011 Cadillac DTS?
Yes. Dorman 949-587 fits the front of the 2006-2011 Cadillac DTS and replaces its electronic MagneRide strut with a conventional, passive strut.
Does this front shock absorber conversion kit come with a coil spring and top mount?
No. This front shock absorber conversion kit is one bare front strut; the coil spring and top mount are not included, and the originals are reused.
How long is the Dorman 949-587 strut when fully extended?
The Dorman 949-587 front shock absorber conversion kit has an extended length of 23 in and uses rubber bushings.
What signs suggest a front MagneRide strut is wearing out?
Fluid leaking down the strut body, bouncing that keeps going after a dip, or a hard nose-dive when braking can mean a front strut is worn. Have it checked and replaced promptly.
What tools does installing this front shock absorber conversion kit call for?
A spring compressor may be needed, because this front shock absorber conversion kit reuses the original coil spring and top mount from the old strut.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.