Dorman 976-584 rear drive shaft for the 2009-2012 Land Rover LR2 carries engine torque back to the rear axle. This Dorman drive shaft is a two-piece steel assembly.
- Drawn over mandrel (DOM) steel tubing with no seam, for concentricity, uniform wall thickness and torsional strength
- New yokes, CV joints and U-joints in the assembly
- Bolt-on ends and an adjustable overall length
- Part of the Dorman OE Solutions line, standard replacement grade
Quick facts
- Part: Dorman 976-584 drive shaft
- Fits: 2009-2012 Land Rover LR2
- Position: Rear
- Material: Steel
- Condition: New
A worn drive shaft can show up as vibration that builds with speed, a clunk when you accelerate or let off, or a dented or cracked tube. These signs alone do not prove the drive shaft is the problem, since an out-of-balance tire can feel much the same.
Fits
This rear drive shaft is a direct-fit replacement for the 2009-2012 Land Rover LR2, which takes one, running to the rear axle.
Specifications
Fit and size
- Position: Rear
- Quantity per vehicle: 1
- Shaft diameter: 2.5 in
- Wall thickness: 0.083 in
- Length: 79.88 in
- Overall length: adjustable
- End types: bolt on at both ends
Build and materials
- Construction: two-piece assembly
- Shaft material: Steel
- CV joints: included
- Greaseable: No
- Condition: New
- Country of origin: United States
In the box
One drive shaft assembly with its yokes, CV joints and U-joints. An axle nut is not included.
Installation notes
- Arrives fully assembled, dynamically pre-balanced and ready to install.
Interchange: LR021552 · LR021553
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
Does this rear drive shaft fit the 2009-2012 Land Rover LR2?
Yes. Dorman 976-584 is a rear drive shaft for the 2009-2012 Land Rover LR2, which takes one.
Are the CV joints and U-joints included with this two-piece steel drive shaft?
Yes. The assembly comes with new yokes, CV joints and U-joints, and the package holds one drive shaft. An axle nut is not included.
What is the length of this Dorman OE Solutions drive shaft?
Dorman 976-584 is 79.88 in long, with a 2.5 in shaft diameter and 0.083 in wall thickness. Its overall length is adjustable.
Is a dented tube a reason to replace a steel drive shaft?
Yes. A dent or crack in the tube, or play in the joints, can mean the shaft needs replacing. Have it inspected promptly rather than driving on it.
Is the Dorman 976-584 made from seamless steel tubing?
Yes. It is built from drawn over mandrel (DOM) seamless steel tubing in the USA, and the assembly arrives dynamically pre-balanced.
Reviews
No reviews yet — be the first to review this product.
Write a ReviewWrite a Review