Dorman - OE Solutions Engine Harmonic Balancer P/N:594-120
Dorman 594-018 harmonic balancer for the 1997-2006 Jeep Wrangler 6-cylinder 4.0L and other vehicles damps vibration at the crankshaft. This Dorman harmonic balancer is a direct replacement for the original part.
A worn balancer can show up as cracked or separated rubber, or as new engine vibration or belt noise, though a different fault could be behind any of these. With the engine off and cool, look over the rubber and the markings first, so you know the balancer is the cause before you replace it.
The 1993-2004 Jeep Grand Cherokee 6-cylinder 4.0L and, as a Cherokee harmonic balancer, the 1987-2001 Jeep Cherokee 6-cylinder 4.0L are among the vehicles this part fits, with more besides.
Fit and size
Build and materials
One harmonic balancer and one instruction sheet. This listing is one balancer, and each vehicle takes one. The bolt and washer and mounting hardware are not included, so plan on a new bolt and washer rather than reusing the old ones.
Interchange: PC-4006 · P-D4.0
24056710973179033 · 102005 · 33002920 · 33002920AB · 33002920AC · PB1439N · DA242 · SK594018
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is Dorman 594-018 the right Jeep Wrangler harmonic balancer for a 1997-2006 model with the 6-cylinder 4.0L?
Yes, Dorman 594-018 fits the 1997-2006 Jeep Wrangler 6-cylinder 4.0L. If your car is a different Jeep, look it up in the "Vehicles it fits" section on this page.
Is this Jeep Grand Cherokee harmonic balancer right for a 1993-2004 model with the 6-cylinder 4.0L?
Yes, this Dorman 594-018 balancer fits the 1993-2004 Jeep Grand Cherokee 6-cylinder 4.0L. The fitment lists a quantity of one per vehicle.
Does the engine harmonic balancer come with the bolt and washer?
No. Dorman 594-018 comes with one harmonic balancer and one instruction sheet. The bolt and washer and mounting hardware are not included.
Is this balancer cast iron, and does it have degree markings?
Yes, it is cast iron with degree markings and a keyway. It is a standard replacement grade balancer for a serpentine belt drive.
How can I tell if the rubber bond on a harmonic balancer is going bad?
With the engine off and cool, look for cracked, split or shifted rubber. New engine vibration or belt noise can also be a sign, and a shop can test it further.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.