Dorman - OE Solutions Steering Tie Rod End P/N:540-917
Help keep steering input precise and predictable with the Dorman - OE Solutions Tie Rod End 540-992. It is an inner tie rod end that directly replaces the original equipment part and serves as a pivoting joint in the steering linkage. It fits many vehicles, among them the 1977-1979 Ford LTD II, 1974-1979 Ford Ranchero and 1974-1979 Ford Thunderbird. See the "Vehicles it fits" section for the full list.
This part has been through an industry-leading evaluation process aimed at smooth, safe operation. A tie rod end wears over time. Signs it may need replacing include loose or wandering steering, excess play in the steering wheel, clunking when turning and uneven tire wear. If a worn inner tie rod end is the cause, this part replaces that joint. Inspect the whole steering and suspension system first, because other worn parts can cause similar signs. A wheel alignment is recommended after installation.
Interchange: 612.65035
61265035 · TA5805 · D3AZ3A131A · DS820 · DS824 · DS824GL · GDS820 · MDS820 · JTE1429
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
What does an inner tie rod end do?
It is a pivoting joint in the steering linkage that passes steering motion toward the wheels while allowing the suspension to move. The Dorman 540-992 is an inner tie rod end.
Which vehicles does the Dorman 540-992 fit?
It fits many vehicles, including the 1977-1979 Ford LTD II, 1974-1979 Ford Ranchero and 1974-1979 Ford Thunderbird. Check the "Vehicles it fits" section for the full list.
What are signs a steering tie rod end may need replacing?
Common signs include loose or wandering steering, extra play in the steering wheel, clunking when turning and uneven tire wear. Other worn parts can cause the same symptoms, so inspect the steering first.
How is this tie rod end built?
Dorman describes a factory-sealed, precision-forged housing that resists corrosion. The part is engineered to decrease wear rate and support overall strength.
Is a wheel alignment needed after installation?
Yes. A wheel alignment is recommended after replacing a tie rod end because the steering linkage geometry changes. Follow the vehicle service information for the installation procedure.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.