Dorman - OE Solutions Steering Tie Rod End P/N:544-162
$19.99
(You save)
Keep your steering input tracking straight through to the wheel with the Dorman - OE Solutions Steering Tie Rod End 544-162. This tie rod end links the steering system to the steering knuckle, and it drops in as a direct-fit replacement for the 2017-2021 Honda Clarity (All engines).
Direct replacement: engineered to install in place of the original tie rod on the listed applications.
Durably designed: a precision-forged, factory-sealed aluminum housing that helps resist corrosion.
Reliably engineered: built to decrease the wear rate and support overall strength.
Ready to install: includes an integrated ball joint, black dust boot, plus a cotter pin and nut; mounting hardware is included.
The unit is pre-greased and sealed with no grease fitting, so it is not greaseable or serviceable. It uses a bent design with a tapered stud, an aluminum tie rod, and a polymer bearing. Both ends are threaded with clockwise (right-hand) threads — End 1 at 12 mm x 1.25 mm and End 2 at 14 mm x 1.5 mm — and the part is non-adjustable, with no adjusting sleeve. Cataloged for power steering systems. Country of origin: China.
Interchange: Manufacturer part number 544-162 (also 544162).
This part cross-references / interchanges with the following part numbers:
ES958032, 53540TRTJ11
Frequently Asked Questions
What vehicles does this tie rod end fit?
It is a direct-fit replacement for the 2017-2021 Honda Clarity (All engines). Check the Buyer's Guide tab to confirm the fit for your vehicle.
What comes in the package?
The steering tie rod end with an integrated ball joint and black dust boot, plus one cotter pin and one nut. Mounting hardware is included.
Is this tie rod end greaseable?
No. It is pre-greased and sealed from the factory, with no grease fitting, so it is not greaseable or serviceable.
What are the signs this part may need replacing?
Loose or wandering steering, clunking when turning, uneven inner tire wear, and alignment that won't hold can be signs. Diagnose the cause first; if the tie rod end is at fault, this replaces it.
What are the thread specs?
Both ends use clockwise (right-hand) threads: End 1 is 12 mm x 1.25 mm and End 2 is 14 mm x 1.5 mm. The part is non-adjustable with no adjusting sleeve.
Write a Review
Dorman
Dorman - OE Solutions Steering Tie Rod End P/N:544-162
Steering Tie Rod EndThis steering tie rod end directly replaces the original equipment tie rod on specific vehicle applications. It has undergone an industry-leading evaluation process to ensure...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
