Dorman - OE Solutions Steering Tie Rod End P/N:544-709
$65.99
(You save)
Keep steering tight and predictable with the Dorman - OE Solutions Steering Tie Rod End 544-709, a direct-fit replacement for the right side of the 1957-1960 Dodge Truck (All engines). The tie rod end links the steering linkage to the wheel and transmits your steering input to the road, so a worn unit can show up as loose or wandering steering, uneven tire wear, or a clunk when turning — if the original tie rod end is the cause, this replaces it.
Trustworthy replacement: this steering tie rod end assembly drops in for the original equipment on the listed applications.
Durably built: factory-sealed, precision-forged steel housing with a powder-coated finish to resist corrosion.
Reliably engineered: designed to decrease wear rate and support overall strength.
Ready to install: pre-greased with a polychloroprene dust boot, a taper stud, and mounting hardware included.
Specs: 110 mm length; End 1 thread 18 mm, End 2 thread 10 mm, both M1.25 with clockwise (right-hand) direction; straight type; standard replacement grade. No grease fitting is included. Country of origin: Turkey.
Interchange: ES2082R · MS43910 Manufacturer part number 544-709
This part cross-references / interchanges with the following part numbers:
ES2082R, MS43910
Frequently Asked Questions
What vehicles does this tie rod end fit?
It is a direct-fit replacement for the right side of the 1957-1960 Dodge Truck (All engines). Check the Buyer's Guide tab to confirm fitment for your vehicle.
What does a steering tie rod end do?
It connects the steering linkage to the wheel and transmits steering input to the road. A worn one may cause loose steering or uneven tire wear.
Is mounting hardware included?
Yes. Mounting hardware is included. A separate grease fitting is not included, and the unit comes pre-greased from the factory.
What are the thread specifications?
End 1 has an 18 mm thread and End 2 has a 10 mm thread, both with an M1.25 pitch and clockwise (right-hand) thread direction.
What is this tie rod end made of?
It uses a precision-forged steel housing with a powder-coated finish to resist corrosion and a polychloroprene dust boot with a taper stud.
Write a Review
Dorman
Dorman - OE Solutions Steering Tie Rod End P/N:544-709
Steering Tie Rod EndThis steering tie rod end directly replaces the original equipment tie rod on specific vehicle applications. It has undergone an industry-leading evaluation process to ensure...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
