Dorman - OE Solutions Suspension Ball Joint P/N:538-771
Dorman 538-784 front lower outer ball joint for the 2002-2008 Mini Cooper is the pivot that links the suspension to the steering knuckle. This Dorman ball joint is a direct replacement made to fit and perform like the original equipment, so you replace only the failed joint rather than the complete assembly.
A worn ball joint can show up as a clunk over bumps, loose steering or uneven front tire wear. Before you replace this ball joint, rule out worn control arm bushings, tie rod ends and wheel bearings, which can make similar noises. Both front sides are normally replaced together, and this listing is one ball joint.
This ball joint fits the 2002-2008 Mini Cooper, and that car takes two.
Fit and size
Build and materials
One ball joint with its dust boot and one nut. Washers, a castle nut, a cotter pin, a grease fitting and mounting bolts are not included, so plan on new ones rather than reusing the old.
Interchange: 101-5670 · 610.34003
45D2356 · 46D2356A · 31126756309 · 31126783443 · TC1155 · 104500006 · K500006 · FA2286 · GS10506 · MS10506 · 1002001 · JBJ1074 · JBJ745
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is Dorman 538-784 the front lower outer Mini Cooper ball joint for 2002-2008 cars?
Yes. Dorman 538-784 is a front lower outer ball joint for the 2002-2008 Mini Cooper, and that car takes two.
Does the Dorman 538-784 ball joint come with a nut and a dust boot?
Yes. Dorman 538-784 comes with one nut and a polychloroprene dust boot. Washers, a castle nut, a cotter pin and mounting bolts are not included.
Is this suspension ball joint greaseable?
No. This ball joint is not greaseable and has no grease fitting. It uses a polymer bearing and a polychloroprene dust boot.
Could a clunk over bumps mean a worn ball joint?
Yes, it can. A clunk over bumps, loose steering or uneven front tire wear are possible signs, so have the suspension inspected promptly.
Do I need a special tool to install Dorman 538-784?
A ball joint press tool is normally required for installation. The stud has a 12 mm thread with a 1.5 mm pitch.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.