Dorman - OE Solutions Suspension Ball Joint P/N:539-797
Dorman 539-862 front lower ball joint for the 2014-2025 Mazda 3 and other vehicles connects the steering knuckle to the control arm. This suspension ball joint is a bolt-in unit that lets the wheel pivot, and a worn joint is replaced on its own instead of the complete assembly.
A clunk over bumps, loose-feeling steering or uneven front tire wear can mean a worn ball joint, and it should be checked and replaced promptly. These signs alone do not prove the ball joint is the problem, since a worn sway bar link can make a similar knock.
This direct replacement fits and performs like the original equipment on the 2014-2025 Mazda 3, the 2013-2025 Mazda CX-5 and the 2014-2025 Mazda 3 Sport. This listing is one ball joint; the car takes one on each side of the front axle, and the other side is normally replaced at the same time.
Fit and size
Build and materials
Six nuts, six bolts, one cotter pin, one castle nut, one zerk fitting and one ball joint. Bushings and washers are not included.
Interchange: 101-8622
TC8206 · FA965295 · K500395 · MS76505 · TXMS76505
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this a ball joint for the 2014-2025 Mazda 3?
Yes. Dorman 539-862 is a front lower ball joint for the 2014-2025 Mazda 3, and the car takes one on each side. To check another Mazda, look up your car in the "Vehicles it fits" section.
How many ball joints does the 2013-2025 Mazda CX-5 take?
This listing is one front lower ball joint. The car takes two, one on each side of the front axle, so the other side needs its own.
What comes with this Dorman ball joint?
Dorman 539-862 comes with six nuts, six bolts, one cotter pin, one castle nut and one zerk fitting along with the ball joint. Bushings and washers are not included.
What size is the tapered stud on this front lower ball joint?
The tapered stud measures 17.95 mm at one end and 21.4 mm at the other, with a taper of 1.59 in per foot. The stud thread is 1/2 in in diameter with an M1.5 pitch.
Does Dorman 539-862 need a ball joint press to install?
Yes, a ball joint press is normally needed to seat this joint. Its housing press-fit diameter is 45 mm.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.