Dorman - OE Solutions Suspension Ball Joint P/N:540-121
Dorman 540-082 front lower ball joint for the 2011-2018 Chevrolet Silverado 2500 and other vehicles connects the steering knuckle to the control arm and lets the wheel pivot. This Dorman ball joint is precision-engineered to the design and dimensions of the original components, so a failed joint can be replaced without buying the whole assembly.
A clunk over bumps, loose or wandering steering or uneven tire wear can mean a ball joint is worn. Before you replace this one, rule out worn control arm bushings, tie rod ends and wheel bearings, which can produce similar noises and looseness.
The 2011-2018 Chevrolet Silverado 2500, the 2011-2024 Chevrolet Silverado 2500 HD and the 2011-2024 Chevrolet Silverado 3500 HD take this front lower ball joint as a direct-fit replacement, and so do many other vehicles. This listing is one joint and the fitment calls for two per truck, so order two and fit them together. Open the "Vehicles it fits" section to check your exact model and engine.
Fit and size
Build and materials
One ball joint with dust boot and one nut. Washers and bushings are not included.
Interchange: 610.66059
45D10118 · 46D10118A · TC5480 · FA91415 · 19256656 · 614043 · K500232 · GS50553 · MS50553 · 1003016 · JBJ1124
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is the Dorman 540-082 the right ball joint for a 2011-2018 Chevrolet Silverado 2500?
Yes. Dorman 540-082 is a front lower ball joint listed for the 2011-2018 Chevrolet Silverado 2500, two per truck. For another model or engine, open the "Vehicles it fits" section.
Does the Dorman 540-082 come with a nut and dust boot?
Yes. Dorman 540-082 includes one nut and a dust boot. Washers and bushings are not included.
Is this suspension ball joint greaseable?
Yes. This ball joint is greaseable and has a tapered stud with a 16 mm thread diameter and a 1.5 mm thread pitch.
How can I tell if a front lower ball joint is wearing out?
A torn dust boot, a clunk over bumps or loose steering can point to a worn joint. A shop can measure play in the joint to confirm.
Does this press-in ball joint need a special tool?
Yes, a ball joint press tool is normally required for installation. This joint has a press-in mount with a housing press-fit diameter of 53.2 mm.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.