Tighten up a worn corner with the Dorman - OE Solutions Suspension Ball Joint 540-095, a direct-fit replacement for the FRONT LOWER and REAR LOWER positions on the 1995-2001 AM General Hummer and the 2002-2004 and 2006 Hummer H1. This ball joint pivots between the control arm and the steering knuckle, letting the suspension travel up and down while the wheel steers and stays located.
Front lower and rear lower: cataloged for both the front-lower and rear-lower ball joint positions on the listed Hummer applications.
Articulating pivot: the stud and housing allow the control arm and knuckle to move through suspension travel and steering input.
Direct-fit replacement: engineered to install in place of the original ball joint on the applications above.
Signs it may need replacing: clunking or knocking over bumps, loose or wandering steering, and uneven tire wear can indicate a worn ball joint — diagnose the cause before replacing.
Sold individually; order the quantity your vehicle requires. Replacing worn joints in matched sets on the same axle is good practice for balanced suspension.
This part cross-references / interchanges with the following part numbers:
123426451, 12506981, 6006645, K500248, MK500248
Frequently Asked Questions
What is the Dorman 540-095?
It is a Suspension Ball Joint that pivots between the control arm and steering knuckle, allowing the suspension to travel while the wheel steers and stays located.
Which vehicles does it fit?
It is a direct-fit replacement for the 1995-2001 AM General Hummer and the 2002-2004 and 2006 Hummer H1. See the Buyer's Guide tab to confirm your vehicle.
What position is this ball joint for?
It is cataloged for the FRONT LOWER and REAR LOWER ball joint positions on the listed Hummer applications.
What are signs a ball joint may need replacing?
Clunking over bumps, loose or wandering steering, and uneven tire wear can point to a worn ball joint. Diagnose the cause before replacing to confirm the joint is at fault.
What numbers does this part interchange with?
It replaces 123426451, 12506981, 6006645, K500248, and MK500248. The manufacturer part number is 540-095.
Keep steering response tight and your suspension articulating freely with the Dorman - OE Solutions Suspension Ball Joint 540-117. It installs as a direct replacement for the 2005-2010 Jeep Grand...
This suspension ball joint is precision-engineered and rigorously tested to provide reliable replacement for the original equipment on specific vehicles.
Suspension Ball JointThis suspension ball joint is precision-engineered and rigorously tested to provide reliable replacement for the original equipment on specific vehicles.Direct replacement - fits...
Suspension Ball JointThis suspension ball joint is precision-engineered and rigorously tested to provide reliable replacement for the original equipment on specific vehicles.Direct replacement - fits...
Suspension Ball JointThis suspension ball joint is precision-engineered and rigorously tested to provide reliable replacement for the original equipment on specific vehicles.Direct replacement - fits...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
