Dorman - OE Solutions Suspension Ball Joint P/N:540-071
Dorman 540-112 front upper ball joint for the 2011-2015 Jeep Grand Cherokee and other vehicles links the steering knuckle to the control arm. The suspension ball joint lets the wheel steer and move with the suspension.
A clunk over bumps, loose or wandering steering and uneven front tire wear can mean a worn ball joint. These signs alone do not prove it, since a worn control arm bushing can cause similar noise.
It is a direct-fit ball joint replacement for the 2011-2015 Jeep Grand Cherokee and the 2011-2015 Dodge Durango. Both take two, one on each side of the front axle. This listing is one ball joint, and the upper ball joint on the other side of that axle is normally replaced at the same time.
Fit and size
Build and materials
One ball joint and one nut. A castle nut, cotter pin, washers, bushings and grease fitting are not included, so plan on new ones where the car needs them.
Interchange: TC4235 · TC5528 · TC7657 · FA500285 · K500285 · GS25551 · MS25551 · TXMS25551
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this the right 2011-2015 Jeep Grand Cherokee ball joint?
Yes. Dorman 540-112 is a front upper ball joint for the 2011-2015 Jeep Grand Cherokee, with one on each side of the front axle.
Does this front upper ball joint work as a 2011-2015 Dodge Durango ball joint?
Yes. This front upper ball joint fits the 2011-2015 Dodge Durango, which takes two, one on each side of the axle.
Does the Dorman 540-112 come with a nut and cotter pin?
The Dorman 540-112 comes with one ball joint and one nut. A castle nut, cotter pin, washers, bushings and a grease fitting are not included.
What are the bearing and dust boot made of on this ball joint?
This ball joint has a polymer bearing and a polychloroprene dust boot, with steel construction. It is not greaseable and not adjustable.
Do I need a special tool to install this press-in ball joint?
A ball joint press tool is normally required for installation. The housing is a press-in type with a 48.4 mm press-fit diameter.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.