Dorman - OE Solutions Suspension Control Arm Bushing Kit P/N:533-435
Dorman 533-408 front lower control arm bushing kit for the 1978-1983 American Motors Concord and other vehicles gives the control arm a rubber pivot. This suspension control arm bushing kit is a direct replacement matched to the design and dimensions of the original components.
Cracked or split rubber at the pivot, a clunk over bumps or loose steering can mean the bushing is worn. Worn ball joints or tie rods can make similar noises, so look the front end over with the engine off, or have a shop inspect it, to find the cause before replacing the bushing.
The 1978-1983 American Motors Concord, the 1979-1983 American Motors Spirit, the 1978-1980 American Motors AMX and many other American Motors models are covered by this bushing kit. If your car is not named here, look it up in the "Vehicles it fits" section. Each vehicle takes two, one on each side of the front axle. This listing is one bushing, and the other side of that axle is normally done at the same time.
Fit and size
Build and materials
One bushing. Mounting hardware is not included, so plan on new hardware, since the old pieces may not be reusable.
Interchange: 602.56006 · K-3059
TD4829W · FB263 · MS25482 · JBU1634
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Will Dorman 533-408 fit a 1978-1983 American Motors Concord?
Yes. Dorman 533-408 is a front lower control arm bushing kit made for the 1978-1983 American Motors Concord. For other American Motors models, look in the "Vehicles it fits" section.
Does Dorman 533-408 come with mounting bolts?
No. Dorman 533-408 is one rubber bushing, and mounting hardware is not included, so plan on new hardware.
What size is the bushing in this kit?
The bushing has a 14.35 mm inside diameter and a 40 mm outside diameter. It is 52.5 mm long and 40 mm wide.
How can I tell a front lower control arm bushing is worn?
Cracked, split or squeezed-out rubber at the pivot, a clunk over bumps or loose steering can mean the bushing is worn.
Does this bushing kit interchange with K-3059?
Yes. K-3059 is one of the interchange numbers listed for Dorman 533-408.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.