Dorman - OE Solutions Suspension Control Arm Bushing P/N:531-774
Dorman 531-385 lower control arm bushing for the 1959-1964 Chevrolet Impala and other vehicles cushions the control arm pivot. This Dorman control arm bushing replaces just the worn bushing instead of the complete control arm.
A worn suspension control arm bushing can show up as clunks over bumps, loose or vague steering, or uneven tire wear, though worn shocks or ball joints can make similar noises. Before you replace it, look the bushing over with the engine off for cracked, split or torn rubber, so you know the bushing is the cause.
This bushing is a direct replacement across a wide range of Chevrolet models, led by the 1959-1964 Chevrolet Impala, the 1963-1982 Chevrolet Corvette and the 1960-1965 Chevrolet Corvair. If your Chevrolet is not one of those three, find its years in the "Vehicles it fits" section. This listing is one bushing, and the fitment gives a quantity of one.
Fit and size
Build and materials
One bushing. Mounting hardware, a bracket and a dust boot are not included, so plan on new fasteners, since the old ones may not be reusable.
Interchange: FB153 · 3749296
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Does Dorman 531-385 work as a 1959-1964 Chevrolet Impala control arm bushing?
Yes. Dorman 531-385 is listed for the 1959-1964 Chevrolet Impala as a front lower and rear lower control arm bushing, and other Chevrolet years are in the "Vehicles it fits" section.
Is 531-385 one of the Corvette control arm bushings for a 1963-1982 Chevrolet Corvette?
Yes. Dorman 531-385 is listed for the 1963-1982 Chevrolet Corvette, with a quantity of one for that application.
What are the inside and outside diameters of this control arm bushing?
The inside diameter is 19 mm and the outside diameters are 32 mm and 33.7 mm. The mounting hole diameter is 18.4 mm and the length is 47.5 mm.
Does Dorman 531-385 come with a bracket or mounting hardware?
No. Dorman 531-385 is one bushing only, with no mounting hardware, bracket or dust boot. Plan on new fasteners, since the old ones may not be reusable.
What is this control arm bushing made of?
Dorman 531-385 is made of rubber and steel and has a rust-resistant coating.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.