Dorman - OE Solutions Suspension Control Arm Bushing P/N:533-636
Dorman 533-689 front lower control arm bushing for the 2011-2018 Volkswagen Jetta and other vehicles lets the control arm pivot in its mount. This Dorman control arm bushing can be replaced on its own instead of the whole control arm.
A worn bushing can show up as a clunk over bumps, loose steering feel or uneven tire wear. These signs alone do not prove the bushing is at fault; a worn ball joint can cause them as well.
This bushing is a front lower control arm part for the 2011-2018 Volkswagen Jetta, the 2012-2022 Volkswagen Passat and the 2014-2020 Volkswagen Caddy, and for other vehicles too. Open the "Vehicles it fits" section to check your exact model and engine. This listing is one bushing; the other side of the front axle is normally done at the same time.
Fit and size
Build and materials
One control arm bushing. The vehicles take two. Mounting hardware, a bracket and a dust boot are not included, so plan on new fasteners rather than reusing the old ones.
Interchange: FB201725 · K201630 · K201724 · K201725 · MS70461 · 1426023 · 1K0407183M · 1K0407183P · 5C0407183A
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this the Jetta control arm bushing for a 2011-2018 Volkswagen Jetta?
Yes. Dorman 533-689 is listed for the 2011-2018 Volkswagen Jetta as a front lower rearward bushing, and the car takes two.
Is this the Passat control arm bushing for a 2012-2022 Volkswagen Passat?
Yes. Dorman 533-689 is listed for the 2012-2022 Volkswagen Passat in the same front lower rearward position, and the car takes two.
Does this bushing come with a bracket or mounting hardware?
No. This listing is one bushing; mounting hardware, a bracket and a dust boot are not included.
What are the inside and outside diameters of this bushing?
Dorman 533-689 has a 12.2 mm inside diameter and a 60 mm outside diameter. The mounting hole diameter is 18.4 mm.
Is this rubber and steel bushing the same as a suspension control arm bushing?
Yes. Suspension control arm bushing is another name for this part. It is a standard replacement grade made of rubber and steel.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.