Dorman - OE Solutions Suspension Control Arm Bushing P/N:533-943
Dorman 533-695 rear upper outer control arm bushing for the 2005-2025 Volkswagen Jetta and other vehicles cushions the control arm pivot. A Dorman control arm bushing like this one lets you replace the worn bushing instead of the whole arm.
A worn suspension control arm bushing can show up as a clunk from the rear suspension over bumps, cracked or split rubber, or loose handling. Before you replace this bushing, look over the rest of the rear suspension for other worn parts, because a clunk or loose feel can have more than one source.
Listed for a wide range of Volkswagen, Audi and SEAT models, it works as a Jetta control arm bushing for 2005-2025 models and also fits the 2012-2019 Volkswagen Passat and the 2009-2024 Volkswagen Tiguan. Driving another car? Look up your year and model in the "Vehicles it fits" section. This listing is one bushing; the other side of the same axle is normally done at the same time.
Fit and size
Build and materials
This listing holds one bushing; the vehicle takes two. Mounting hardware and a bracket are not included, so plan on new fasteners, since the old ones may not be reusable.
Interchange: FB943619 · BU19790 · 4673756 · 1K0505203A
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Are VW Tiguan control arm bushings for the 2009-2024 Tiguan covered by Dorman 533-695?
Yes. Dorman 533-695 is a rear upper outer control arm bushing listed for the 2009-2024 Volkswagen Tiguan, and the vehicle takes two. Check other years in the "Vehicles it fits" section.
Is Dorman 533-695 a Passat control arm bushing for the 2012-2019 model years?
Yes. Dorman 533-695 is listed for the 2012-2019 Volkswagen Passat as a rear upper outer control arm bushing, and the vehicle takes two.
Does Dorman 533-695 come with mounting bolts or a bracket?
No. Dorman 533-695 is one control arm bushing only. Mounting hardware and a bracket are not included, and the vehicle takes two bushings.
What are the diameters and rubber hardness of this rear control arm bushing?
The outside diameter is 45 mm, the inside diameter is 12.2 mm and the mounting hole is 12.2 mm. The rubber is 55-75 Shore A durometer.
Does Dorman 533-695 cross to the number 1K0505203A?
Yes. 1K0505203A is one of the interchange numbers for Dorman 533-695, along with FB943619, BU19790 and 4673756.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.