Dorman - OE Solutions Suspension Control Arm Bushing P/N:533-987
Dorman 533-801 rear lower control arm bushing for the 2001-2008 Ford Escape and other vehicles cushions the pivot where the control arm attaches. Also listed as a suspension control arm bushing, it lets the arm pivot while limiting vibration passed on to the vehicle.
A worn bushing can show up as a clunk over bumps, loose or wandering handling, or uneven tire wear. Worn rear shocks, a bent control arm or a loose wheel bearing can produce similar noises and handling changes, so pin down the cause before you buy a bushing.
This is a direct-fit rear lower control arm bushing replacement for the 2001-2008 Ford Escape, which takes four, and for the 2001-2006 and 2008 Mazda Tribute and the 2005-2008 Mercury Mariner, which take two each. Replace the matching bushing on the other side at the same time; this listing is one bushing.
Fit and size
Build and materials
One bushing. Mounting hardware, a bracket and a dust boot are not included, so plan on new fasteners.
Interchange: 602.65046
TD4477W · 12200360 · YL8Z5500AB · K200360 · FB1126 · GS40428 · MS40428 · 1408008 · 1408080 · JBU1480
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is the Dorman 533-801 a 2001-2008 Ford Escape control arm bushing?
Yes. Dorman 533-801 is a rear lower control arm bushing for the 2001-2008 Ford Escape, and the Escape takes four of them.
Does this Dorman control arm bushing come with hardware?
No. Dorman 533-801 is one bushing; mounting hardware, a bracket and a dust boot are not included, so plan on new fasteners.
What size is the 533-801 control arm bushing?
Dorman 533-801 has a 21 mm inside diameter, a 32.8 mm outside diameter and an 18.4 mm mounting hole. It is 50 mm long with a 23.8 mm wall thickness.
How can I check a rear lower control arm bushing for wear?
A clunk over bumps, loose or wandering handling, or uneven tire wear can be signs of a worn bushing. Looking at the bushing itself means getting under the vehicle, so a shop can inspect it.
Can I replace just the bushing instead of the whole control arm?
Yes. This bushing is intended to replace the worn bushing alone, so the control arm itself does not have to be replaced.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.