Dorman - OE Solutions Suspension Control Arm Bushing P/N:540-854
Quiet the clunks and tighten up steering response with the Dorman control arm bushing (MPN 540-827), a direct-fit replacement for the front left lower rearward position on the 2007-2012 Acura RDX. It cushions the connection between the suspension control arm and the chassis, helping locate the arm while isolating road vibration and impact harshness.
Worn control arm bushings often reveal themselves through clunking or knocking over the suspension, imprecise steering, or uneven tire wear. If a failed front left lower rearward bushing is the cause, this replaces it. For engine-specific coverage on your RDX, see the Buyer's Guide tab.
Interchange: 51396STKA02
This part cross-references / interchanges with the following part numbers:
What position does this bushing fit?
It is cataloged for the front left lower rearward control arm position on the 2007-2012 Acura RDX.
Does this fit my 2010 Acura RDX?
Yes. The 2010 Acura RDX falls within the 2007-2012 RDX coverage for this bushing. Confirm the position and fitment for your vehicle in the Buyer's Guide tab.
What does a control arm bushing do?
It cushions the joint between the control arm and the chassis, helping locate the arm while isolating road vibration and impact from the cabin.
What are signs this bushing may need replacing?
Common signs include clunking or knocking over bumps, loose or imprecise steering, and uneven tire wear. Have the cause diagnosed before replacing.
What number does this bushing interchange with?
It cross-references 51396STKA02. Match the interchange number and confirm fitment for your vehicle before ordering.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.