Dorman - OE Solutions Suspension Control Arm Bushing P/N:540-831
$120.99
(You save)
Restore the cushioned pivot between the suspension control arm and the chassis with the Dorman - OE Solutions Suspension Control Arm Bushing 540-831. It installs as a direct-fit replacement for the 2013-2018 Acura RDX [All], so you can renew a worn or cracked bushing instead of replacing the entire control arm.
Steel and rubber construction: locates the control arm while damping road vibration and noise; finished in black.
Rust-resistant coating: helps protect the metal against corrosion.
Bolt-on design with bracket included: mounting hardware and a dust boot are not included — consult the vehicle service information for the correct fasteners and whether they may be reused.
Standard-replacement grade: sized to the original bushing's dimensions and quality-checked before shipping.
Key dimensions: 18.5 mm inside diameter, 73.4 mm outside diameter, 10.4 mm wall thickness, and 74 mm between mounting holes. Sold individually; the package contains one control arm bushing. Country of origin: Taiwan.
Manufacturer part number 540-831.
This part cross-references / interchanges with the following part numbers:
51396TX4A01, 51396TX4H51
Frequently Asked Questions
What does the Dorman 540-831 control arm bushing do?
It cushions the pivot where the suspension control arm attaches to the chassis, locating the arm and damping road vibration and noise. A worn bushing lets the arm shift and can loosen handling.
Which vehicles does this bushing fit?
It is a direct-fit replacement for the 2013-2018 Acura RDX [All]. Check the Buyer's Guide tab to confirm the fit for your specific vehicle.
Does it come with mounting hardware?
A bracket is included, but mounting hardware and a dust boot are not. Consult the vehicle service information for the correct fasteners and whether they may be reused.
What are the signs this bushing may need replacing?
Clunking over bumps, imprecise or wandering steering, uneven tire wear, and vibration can be signs. Diagnose the cause first, since these symptoms can have other sources.
What is the bushing made of and what are its dimensions?
It uses steel and rubber construction with a rust-resistant coating, in black. It measures 18.5 mm inside diameter, 73.4 mm outside diameter, 10.4 mm wall, with 74 mm between the mounting holes.
Write a Review
Dorman
Dorman - OE Solutions Suspension Control Arm Bushing P/N:540-831
Give your suspension a fresh, vibration-damping pivot with the Dorman - OE Solutions Suspension Control Arm Bushing 540-827. It installs as a direct-fit replacement in the front left lower rearward...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
