Dorman - OE Solutions Suspension Control Arm P/N:520-292
Dorman 520-421 front left lower control arm for the 1988-1993 Toyota Corolla links the wheel assembly to the chassis. This Dorman control arm replaces a worn or damaged arm.
Signs of a worn suspension control arm can include a clunk over bumps, uneven tire wear or cracked bushing rubber. A worn ball joint or tie rod end can be behind those signs too, so find the cause before you buy. Front control arms are normally replaced as a pair. This listing is one arm for the front left, and the front right is a separate part, one on each side of the axle.
This is a direct-replacement lower control arm for the 1988-1993 Toyota Corolla. Precision-engineered to the design and dimensions of original components, it fits and performs like the original equipment.
Fit and size
Build and materials
One control arm. The ball joint, mounting hardware and grease fitting are not included, and the old fasteners may not be reusable, so plan on new bolts.
Interchange: 101-6578
TC1118 · CA14075 · 5CB86009 · RK640809 · GS8070 · CMS8070 · 2605400 · JTC502 · 4334019016 · 4806912110
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is the Dorman 520-421 the front left lower control arm for the 1988-1993 Toyota Corolla?
Yes. Dorman 520-421 is a front left lower control arm for the 1988-1993 Toyota Corolla. The front right side is a separate part.
Is a ball joint included with this 1988-1993 Toyota Corolla lower arm?
No. The Dorman 520-421 comes with its bushings, but the ball joint, mounting hardware and grease fitting are not included.
What are the bushing sizes on this Dorman lower control arm?
The bushing measures 14.3 mm inside diameter and 39.6 mm outside diameter, and it is 92 mm long.
How can I check the bushings on this front lower control arm?
With the car parked and the engine off, look for cracked, torn or separated rubber. A clunk over bumps or uneven tire wear can also point to wear; a shop can test the arm's play.
Is the finish on this control arm powder coated?
Yes. The Dorman 520-421 is a steel arm with a powder-coated finish. Its country of origin is Taiwan.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.