Dorman - OE Solutions Suspension Control Arm P/N:522-844
Dorman 520-844 rear right upper control arm for the 1993-2002 Mitsubishi Mirage and other vehicles connects the rear wheel assembly to the body.
A worn arm can show up as a clunk or knock from the rear suspension over bumps, uneven rear tire wear or torn bushing rubber. Before you replace it, rule out a loose shock mount, a tired spring or a neighboring link, since those can make similar noises.
The vehicles it fits include the 1993-2002 Mitsubishi Mirage, the 1993-1996 Eagle Summit and the 1993-1994 Dodge Colt. It is a direct replacement that fits and performs like the original equipment on specific vehicles. If your car is not named here, look it up in the "Vehicles it fits" section below. This listing is one arm for the rear right upper position, so the left upper arm on that axle is a separate part and is normally replaced at the same time. On the 1993-2002 Mitsubishi Mirage, this side takes one arm.
Fit and size
Build and materials
One control arm with its rubber bushings. The ball joint, mounting hardware and grease fitting are not included, so plan on new hardware, since the old bolts may not be reusable.
Interchange: 102-6437
TC5237 · CA6261 · 2CB80013 · RK640894 · GK80641 · CMK80641 · MB809221 · MR491346 · 2743104 · 2743106 · SK620039 · JTC805
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this Summit control arm right for the 1993-1996 Eagle Summit?
Yes. Dorman 520-844 is listed for the 1993-1996 Eagle Summit in the rear right upper position. The left side is a separate part.
Does the Dorman control arm come with bushings?
Yes. Dorman 520-844 comes with its rubber bushings. The ball joint, mounting hardware and grease fitting are not included.
What size are the bushings on this Dorman upper control arm?
The bushing inside diameter is 14.3 mm, the outside diameter is 39.6 mm and the length is 92 mm. The mounting holes are 84 mm apart.
Is the Dorman OE Solutions suspension control arm made of steel?
Yes. Dorman 520-844 has a steel arm with a powder-coated finish and rubber bushings.
Is MR491346 the same as Dorman 520-844?
Yes. MR491346 is listed as an interchange number for this rear right upper control arm, and it appears on the Interchange line.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.