Dorman - OE Solutions Suspension Control Arm P/N:521-698
Dorman 521-705 rear upper control arm for the 2005-2010 Jeep Grand Cherokee and other vehicles locates the rear wheel as the suspension moves. This Dorman control arm, also called a suspension control arm, replaces a worn or damaged rear upper arm.
A worn or damaged arm can show up as clunking over bumps, uneven tire wear or a loose feel at the rear. Before you replace the arm, rule out loose bolts, worn shocks and other worn rear suspension parts that could produce similar noises.
It is a control arm for the 2005-2010 Jeep Grand Cherokee and the 2006-2010 Jeep Commander, listed for the rear left upper and rear right upper positions. Each position takes one arm and this listing is a single arm, so a car being done on both sides takes two, normally replaced together.
Fit and size
Build and materials
One control arm with its bushings. Mounting hardware, a ball joint and a grease fitting are not included; plan on new mounting bolts, since the old ones may not be reusable.
Interchange: 52089629AA · 52089629AB · 52089629AC · 5290953AA · 5290953AB · 5290953AC · 5290953AD · TC6610 · CA2132 · RK641865 · GS251055 · CMS251055 · 2606774 · 2CB28106 · 1506130
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is Dorman 521-705 a 2005 Jeep Grand Cherokee upper control arm for the rear?
Yes. Dorman 521-705 is listed for the rear left upper and rear right upper positions on the 2005-2010 Jeep Grand Cherokee, and this listing is one arm.
Does Dorman 521-705 include bushings and a ball joint?
Yes to the bushings, no to the ball joint. A grease fitting and mounting hardware are not included either, so plan on new bolts.
What are the bushing dimensions on Dorman 521-705?
The bushing inside diameter is 14.3 mm, the outside diameter is 39.6 mm and the bushing length is 92 mm. The bushings are rubber, and the arm is 262.5 mm long.
Is this rear upper control arm steel, and is it coated?
Yes, it is steel with a powder-coated finish, and it is a casting/forged arm with a press-in end 2.
Which signs can mean the bushings on a rear upper control arm are worn?
Clunking over bumps, uneven tire wear or a loose feeling at the rear can mean worn bushings or a worn arm. A shop can inspect the arm and bushings to confirm.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.