Dorman - OE Solutions Suspension Control Arm P/N:521-603
Help keep the rear wheels properly located with the Dorman - OE Solutions Control Arm 521-837, a rear lower rearward control arm built as a direct-fit replacement for the 1996-2000 Honda Civic and the 1997-2000 Acura EL. The catalog lists it for the rear lower rearward position on both the left and right sides. See the Buyer's Guide tab for engine and trim details.
This Dorman control arm is precision-engineered and thoroughly tested to serve as a reliable stand-in for the original equipment on the listed vehicles. It is designed to fit and perform like the factory arm it replaces.
A rear lower control arm ties the wheel assembly to the chassis and helps hold suspension geometry as the wheel moves. Signs it may need replacing include clunking from the rear suspension over bumps, uneven tire wear, wandering, or a visibly bent or damaged arm. Diagnose the cause first; if a worn or bent arm is the problem, this Dorman lower control arm replaces it. When the opposite side shows similar wear, replacing both sides together is recommended, and a wheel alignment check is advised after installation.
Interchange: 102-6010
1026010 · TC2941 · CA6504 · 52350S04000 · 2CB60117 · 5CB60380 · RK641202 · FA3217 · GS60164 · CMS60164 · 2606216 · 2607672 · SK521837 · 1509016 · X02LA7468
This part cross-references / interchanges with the following part numbers:
Can this replace the rear lower control arms on a 1996-2000 Honda Civic?
Yes. It is a direct-fit replacement for the rear lower rearward position on the 1996-2000 Honda Civic, left or right side. Check the Buyer's Guide tab for your trim.
Is this 1996-2000 Honda Civic control arm also a fit for the 1997-2000 Acura EL?
It is also cataloged for the 1997-2000 Acura EL, in the same rear lower rearward position.
What does a suspension control arm do?
It links the wheel assembly to the chassis, helping to locate the wheel and keep suspension geometry in place as the suspension moves over the road.
What are signs this control arm may need replacing?
Clunking from the rear over bumps, uneven tire wear, wandering, or a visibly bent or damaged arm can indicate a problem. Diagnose the cause first, as other suspension parts can cause similar symptoms.
Should I get an alignment after installing it?
Yes, a wheel alignment check is recommended after replacing a control arm. Follow the vehicle service information for torque values and the correct procedure.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.