Dorman - OE Solutions Suspension Control Arm P/N:522-599
Dorman 522-893 front left lower control arm for the 2003-2006 Mercedes-Benz SL500 and other vehicles connects the left front wheel to the chassis. This Dorman control arm is a direct replacement, built to the design and dimensions of the original arm.
A worn control arm can show up as a clunk over bumps, uneven tire wear or a steering pull. Before you replace this arm, rule out a worn ball joint, a sway bar link or a wheel bearing, since those parts can make similar noises.
This arm is listed for a wide range of Mercedes-Benz SL models, led by the 2003-2006 Mercedes-Benz SL500, the 2003-2006 Mercedes-Benz SL55 AMG and the 2003-2006 Mercedes-Benz SL600, and each car takes one on the front left. Plan to do the front pair at the same time: this listing is one arm for the left side, and the right side is ordered separately.
Fit and size
Build and materials
One control arm with its rubber bushings and mounting hardware. A ball joint is not included.
Interchange: CA5309 · 2113300235 · 2113300435 · 211330043505 · 2203330127 · 2203330227 · 2203330327 · 2203330427 · 2203330727 · 2303300107 · 2303301307 · 2303301507 · 2303303107
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this a 2003-2006 Mercedes SL500 control arm for the front left lower position?
Yes. Dorman 522-893 is listed for the 2003-2006 Mercedes-Benz SL500 and other SL models. Look up your own car in the "Vehicles it fits" section on this page.
Does the Dorman OE Solutions suspension control arm come with bushings and hardware?
Yes. Dorman 522-893 includes rubber bushings and mounting hardware. A ball joint is not included.
What are the bushing dimensions on this control arm?
The bushings measure 14.3 mm inside diameter, 39.6 mm outside diameter and 92 mm long. The arm itself is 320 mm long.
How can I tell if a front lower control arm is wearing out?
Cracked or torn rubber bushings, a clunk over bumps or uneven tire wear can be signs of a worn arm. A shop can inspect the arm and its bushings for play and damage.
Is this control arm made of steel and is it painted?
Yes. Dorman 522-893 is a steel arm with Casting/Forged construction and a painted finish, supplied with rubber bushings.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.