Dorman - OE Solutions Suspension Control Arm P/N:526-067
Help keep the rear wheel tracking where it belongs with the Dorman control arm 526-232, a direct replacement for the rear right lower rearward arm on the 2005-2010 Honda Odyssey. See the "Vehicles it fits" section for engine details.
This suspension control arm is precision-engineered and rigorously tested to serve as a dependable replacement for the original equipment on specific vehicles.
As a Dorman lower control arm for the rear right position, it connects the rear wheel assembly to the chassis and helps hold wheel position and alignment as the suspension moves. Signs this 2005-2010 Honda Odyssey control arm may need replacing include clunking or rattling from the rear over bumps, uneven rear tire wear and vague or wandering handling. Diagnose the cause first. If a worn or bent arm is behind the problem, this part replaces it. It is cataloged for the right side of the vehicle. After installation, have the wheel alignment checked. Consult the vehicle service information for the correct fasteners, torque values and whether the original fasteners may be reused.
Interchange: TC7284 · CA14893 · 52350SHJA00 · 5CB60425 · RK643935 · GS601216 · CMS601216 · 2608488
This part cross-references / interchanges with the following part numbers:
Is this the right control arm for a 2005-2010 Honda Odyssey?
Yes. It is listed for the 2005-2010 Honda Odyssey in the rear right lower rearward position. See the "Vehicles it fits" section for full vehicle details.
What does a rear lower control arm do?
It connects the rear wheel assembly to the vehicle's chassis. It helps keep the wheel in position and hold alignment as the suspension moves over the road.
Which position does part 526-232 install in?
It is cataloged for the rear, right side, lower rearward position. Make sure the arm you are replacing is in that same location before ordering.
What are signs that a control arm may need replacing?
Common signs include clunking or rattling over bumps, uneven tire wear and wandering or vague handling. These symptoms can have other causes, so have the suspension inspected first.
Do I need a wheel alignment after installing it?
A wheel alignment is recommended after replacing a control arm. Check the vehicle service information for the correct fasteners and torque values.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.