Tie the front stabilizer bar back to the suspension with the Dorman - OE Solutions Suspension Stabilizer Bar Link Kit 542-459. This front link kit drops in as a direct-fit replacement for the 2003-2013 Subaru Forester, 2002-2016 Subaru Impreza, 2005-2009 Subaru Legacy and Outback, 2012-2014 Subaru WRX, and 2013-2014 Subaru WRX STI (All engines), where it connects the stabilizer bar to the suspension to help control body roll and keep steering response consistent.
- Precision-engineered and tested: built and quality-checked to install and perform like the original link on the listed vehicles.
- Steel, coated construction: a steel link with a coated finish that helps resist rust and corrosion; overall length 340 mm.
- Greaseable joint: threaded 14 mm ends (1.5 mm thread pitch), metal bearings, dust boots, and grease fittings so the joint can be re-lubricated.
- Included hardware: comes with locking nuts; bushings, bolts, washers, and spacers are not included.
Worn stabilizer bar links often cause clunking or rattling over bumps and looser, less-controlled handling; if a failed link is the cause of that noise, this kit replaces it. The listed applications use two links per vehicle, so order 2 for a complete left-and-right replacement. Because bolts and washers are not included, consult the vehicle service information for the correct fasteners and whether they may be reused. Country of origin: China.
Interchange: K750049 · GS80811 · MS80811 · TXMS80811 · Manufacturer part number 542-459 (also 542459)
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
Which Subaru models does this stabilizer bar link kit fit?
It's a direct-fit front link for the 2003-2013 Forester, 2002-2016 Impreza, 2005-2009 Legacy and Outback, 2012-2014 WRX, and 2013-2014 WRX STI (All engines). Check the Buyer's Guide tab to confirm your vehicle.
How many links do I need?
The listed applications use two links per vehicle, so order 2 for a complete left-and-right replacement.
Is this link greaseable?
Yes. It includes grease fittings so the joint can be re-lubricated. It is not pre-greased from the factory.
What is included in the kit?
The kit includes the stabilizer bar link with metal bearings, dust boots, grease fittings, and locking nuts. Bushings, bolts, washers, and spacers are not included.
What are the signs of a worn stabilizer bar link?
Common signs are clunking or rattling over bumps and looser handling. Diagnose the cause first; if a failed link is responsible, this kit replaces it.
Write a Review