Dorman - OE Solutions Suspension Strut Rod P/N:528-331
$212.99
(You save)
Keep the front suspension located and stable with the Dorman - OE Solutions Suspension Strut Rod 528-331. This front strut rod ties the lower control arm to the chassis, helping control fore-aft movement of the suspension as you accelerate and brake. It drops in as a direct-fit replacement for the 1989-1998 Nissan 240SX — see the Buyer's Guide tab for the full engine breakdown.
Front position: replaces the original front suspension strut rod on the listed applications.
Reliable fit: precision-engineered to match the design and dimensions of the original component so it installs cleanly.
Durable construction: built to strict standards using sturdy, safe materials.
Quality controlled: rigorously tested, with thorough checks intended to support long service life.
If a bent, corroded, or worn strut rod is behind clunking, wandering, or uneven front-tire wear, replacing it restores the intended location of the control arm. Strut rods work as a pair on many suspensions — inspect both sides and replace as directed by the vehicle service procedure. Always confirm fitment for your vehicle before ordering.
This part cross-references / interchanges with the following part numbers:
2CB30440, CMS301143, 2607328, 5446865F10
Frequently Asked Questions
What is a suspension strut rod?
It's a rod that connects the lower control arm to the chassis, helping locate the suspension and control fore-aft movement during acceleration and braking.
Does this fit my vehicle?
It's a direct-fit front strut rod for the 1989-1998 Nissan 240SX. Check the Buyer's Guide tab and confirm fitment for your specific vehicle before ordering.
Is this a front or rear part?
This is a front suspension strut rod, replacing the original front unit on the listed applications.
What are signs my strut rod may need replacing?
Clunking, front-end wandering, or uneven front-tire wear can be signs of a bent, corroded, or worn strut rod, though these symptoms can have other causes—diagnose first.
Should I replace both sides at once?
Strut rods often work as a pair. Inspect both sides and replace as directed by the vehicle service procedure for balanced suspension performance.
Write a Review
Dorman
Dorman - OE Solutions Suspension Strut Rod P/N:528-331
Restore secure suspension geometry with the Dorman - OE Solutions Suspension Control Arm 528-341, a Dorman control arm that arrives with the ball joint and rubber bushings already installed for a...
Suspension Control ArmThis suspension control arm is precision-engineered and rigorously tested to provide reliable replacement for the original equipment on specific vehicles.Direct replacement -...
This suspension control arm is precision-engineered and rigorously tested to provide reliable replacement for the original equipment on specific vehicles.Reliable fit - precision-engineered to match...
Engineered for passenger safety and rigorously tested for secure performance, this trailing arm was designed as a direct replacement for your vehicle's original part. Industry-leading evaluation...
Engineered for passenger safety and rigorously tested for secure performance, this trailing arm was designed as a direct replacement for your vehicle's original part. Industry-leading evaluation...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
