Timken HB4010A drive shaft center support for the 2005-2006 Dodge Ram 1500 and other vehicles supports the middle of the drive shaft. It is also sold as a driveline center support bearing.
- Pre-greased, pre-sealed bearing inserts
- Additional grease barrier between the bearing retainer caps and the sealed bearing to help extend bearing life
- Bracket made from reinforced heavy-gauge cold-rolled steel for strength and durability
- Rubber cushion that absorbs and isolates vibration
- Inspected to Timken performance and quality standards
Quick facts
- Part: Timken HB4010A drive shaft center support
- Fits: 2005-2006 Dodge Ram 1500 and other vehicles
- Condition: New
A rumble or vibration that changes with vehicle speed can mean the bearing or its rubber cushion has worn, but a worn U-joint or an out-of-balance shaft can feel much alike. Before you replace anything, have a shop look the cushion over for cracks or tearing on a lift.
Fits
This center support fits the 2005-2006 Dodge Ram 1500, the 2000-2004 Chevrolet Silverado 2500 and the 2002-2004 Dodge Dakota, along with many other Chevrolet, GMC and Dodge models. The 2000-2004 Chevrolet Silverado 2500 takes one. If your truck or van is not named here, look it up in the "Vehicles it fits" section.
Specifications
- Quantity per vehicle: 1
- Bearing inserts: pre-greased and pre-sealed, with an additional grease barrier
- Bracket: reinforced heavy-gauge cold-rolled steel
- Cushion: rubber, absorbs and isolates vibration
- Condition: New
Interchange: HB108D · HB88506 · 2120301X
This part cross-references / interchanges with the following part numbers:
HB108D, HB88506, 2120301X
Frequently Asked Questions
Does the Timken HB4010A fit a 2005-2006 Dodge Ram 1500?
Yes. Timken HB4010A fits the 2005-2006 Dodge Ram 1500 and also the 2000-2004 Chevrolet Silverado 2500. For other trucks and vans, look in the "Vehicles it fits" section.
Is the bearing in this drive shaft center support pre-greased?
Yes. The bearing inserts come pre-greased and pre-sealed, with an additional grease barrier between the bearing retainer caps and the sealed bearing.
What is the bracket on the Timken HB4010A made of?
Timken HB4010A has a bracket made from reinforced heavy-gauge cold-rolled steel. A rubber cushion on it absorbs and isolates vibration.
How can I tell if my drive shaft center support is wearing out?
A rumble or vibration that changes with speed, or a cracked or torn rubber cushion, can point to wear. A shop can inspect it safely on a lift.
Does Timken HB4010A replace HB108D?
Yes. HB108D is one of the numbers this Timken HB4010A replaces, along with HB88506 and 2120301X.
