Keep your rear brake pads properly seated, positioned, and rattle-free with the Dynamic Friction Company Disc Brake Hardware Kit (MPN 340-74009, also written 34074009). This rear-position hardware kit is a direct-fit replacement for the 2000-2006 Audi TT, the 1999-2006 Volkswagen Golf, and the Volkswagen Jetta in both 1999-2005 and 2010 model years — see the Buyer's Guide tab for engine-level detail on your vehicle. Replacing the small clips and hardware during a brake job helps ensure the pads locate correctly and move freely in the caliper bracket.
This disc brake hardware kit fits the rear axle only. Refer to the Buyer's Guide tab to confirm the correct application for your vehicle before ordering.
What is this Dynamic Friction 340-74009 kit?
It is a rear disc brake hardware kit that supplies the clips and hardware used to correctly position and secure the brake pads in the caliper bracket during a brake job.
Which vehicles does it fit?
It is a direct-fit replacement for the 2000-2006 Audi TT, 1999-2006 Volkswagen Golf, and Volkswagen Jetta in 1999-2005 and 2010. Check the Buyer's Guide tab to confirm your vehicle.
Is this for the front or rear brakes?
This hardware kit is cataloged for the rear position only. It is not intended for the front axle.
Should I replace the hardware when I install new pads?
Fresh hardware is recommended with a pad replacement so the pads seat correctly and move freely. Reused, corroded clips can cause noise or uneven pad movement.
Does this kit include brake pads?
No. This listing is for the hardware kit only; brake pads and rotors are sold separately.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
