Keep your rear brakes seated, quiet, and moving freely with the Dynamic Friction Company Disc Brake Hardware Kit 340-76088 (also written 34076088). This rear brake hardware kit supplies the clips, springs, and abutment hardware that locate the pads, control pad movement in the caliper bracket, and help limit rattle and squeal — the small parts that should be refreshed whenever the pads are serviced. It installs on the rear axle of the 2024-2026 Mazda CX-90, the 2025-2026 Mazda CX-70, and the 2018-2022 Toyota C-HR.
Reusing worn or corroded clips and springs is a common cause of uneven pad wear, sticking pads, and brake noise, so fitting fresh hardware with every pad set is good practice. Easy assembly and removal make installation straightforward during a routine rear brake job.
What is included in this kit?
It is a rear brake hardware kit supplying the clips, springs, and abutment hardware that locate and retain the brake pads. Brake pads are not included.
Which vehicles does the 340-76088 fit?
It fits the rear axle of the 2024-2026 Mazda CX-90, 2025-2026 Mazda CX-70, and 2018-2022 Toyota C-HR. See the Buyer's Guide tab to confirm your vehicle.
Should I replace brake hardware with every pad change?
It is good practice. Worn or corroded clips and springs can cause uneven pad wear, sticking pads, and noise, so fresh hardware helps the new pads move and seat properly.
Does this hardware help reduce brake noise?
Yes. The clips and springs locate the pads and control their movement in the caliper bracket, which helps limit rattle and squeal when the hardware is in good condition.
Is this kit for the front or rear brakes?
This is a rear brake hardware kit, cataloged for the rear axle of the listed applications.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
