FEL-PRO Engine Cylinder Head Gasket Set P/N:HS 26587 PT
FEL PRO GASKETS 26587 PT cylinder head gasket for the 2009-2014 Acura TL V6 3.7L and other vehicles seals the joint between the cylinder head and the engine block. The engine cylinder head gasket holds in combustion pressure, coolant and oil.
Coolant or oil seeping at the head-to-block joint, overheating or white exhaust smoke can point to a leaking head gasket, though these signs have other causes too. Find the cause before replacing it: with the engine off and cool, look over the joint for seepage or wet residue, and leave compression or leak-down tests to a shop. This listing is one gasket; the V6 takes one per cylinder head, two in total, and both are normally replaced together.
The 2009-2014 Acura TL V6 3.7L, the 2010-2013 Acura MDX V6 3.7L and the 2010-2013 Acura ZDX V6 3.7L take this gasket, and so do other vehicles. If your car is not one of these, look it up in the "Vehicles it fits" section further down this page.
Fit and size
Build and materials
One cylinder head gasket. Gasket sealant is not included.
Interchange: 12251RKG004 · 611110900
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this the right Acura TL cylinder head gasket for a 2009-2014 TL with the V6 3.7L?
Yes. FEL PRO GASKETS 26587 PT fits the 2009-2014 Acura TL V6 3.7L. The "Vehicles it fits" section on this page shows the other cars it fits.
Does the 26587 PT head gasket come with gasket sealant?
No. Gasket sealant is not included. This listing is one multi-layer steel cylinder head gasket.
What bore size does the FEL PRO GASKETS 26587 PT head gasket have?
The cylinder bore diameter and the head gasket bore are both 90.5 mm. The gasket is multi-layer steel with a proprietary coating.
How can I tell if a cylinder head gasket is leaking?
Coolant or oil seeping at the head joint, overheating or white exhaust smoke can point to it. You can look for seepage with the engine off and cool; a shop can run compression or leak-down tests.
What rough surface finish can the coating on the 26587 PT handle?
The proprietary coating helps withstand rougher sealing surface finishes up to 80 Ra. The embossed sealing beads and steel layers add to the seal on imperfect surfaces.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.