Four Seasons HVAC Blower Control Switch,HVAC Control Switch P/N:37566
Take charge of your cabin airflow with the Four Seasons HVAC Blower Control Switch 20044, a rotary selector blower switch that lets you choose the front blower setting right from the dash. It fits many vehicles, among them the 1992-1998 Ford F-150 and the 1995-2001 Ford Explorer. It is a direct-fit replacement for the listed Ford, Mercury, Mazda and Sterling Truck applications. See the Buyer's Guide tab for the full list.
The blower control switch sends power to the blower motor circuit for the setting you choose. Signs it may need replacing include a blower that works on some settings but not others, a blower that does not run at all, or a fan that cuts in and out as the knob moves. The blower resistor, the motor and the wiring can cause similar symptoms, so diagnose the cause before you replace any part. If a failed switch is the cause, the 20044 replaces it. Follow the vehicle's service information when you remove and install the switch. Four Seasons has more than 50 years of experience in mobile A/C.
Interchange: 1551158 · 207990 · 11120044 · 901817 · 3W7Z13K724BA · F2DZ19986A · F4DH19A642AA · F4DZ19986A · 19194731 · 1711746 · 1174 · YH588 · A07990 · 2911915 · MT1306 · SW11117 · SW11117C · SW1067
This part cross-references / interchanges with the following part numbers:
Is this an ignition switch for the 1992-1998 Ford F150?
No. The Four Seasons 20044 is a rotary HVAC blower control switch that sets the front blower. It is not an ignition switch. It is a direct-fit blower switch for the 1992-1998 Ford F-150.
Does it fit a 1995-2001 Ford Explorer?
Yes. The 1995-2001 Ford Explorer is one of the listed applications. Check the Buyer's Guide tab to confirm it matches your exact vehicle.
What is the current rating of this blower switch?
Four Seasons rates the 20044 to carry up to 20 amps. Its contacts are designed for proper conductivity through the switch.
What are signs the blower control switch may need replacing?
Common signs are a blower that runs on some settings but not others, does not run at all, or cuts out as the knob turns. A bad resistor, motor or wiring can cause the same signs, so diagnose first.
How is the switch protected against corrosion?
The switch is zinc coated to help it resist corrosion.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.