Gates HVAC Heater Hose P/N:19537
Route coolant cleanly between the reservoir and filler neck with the GATES heater hose (P/N 12442), a factory-molded, OEM-style GATES molded heater hose that drops in as a direct-fit replacement on the 2007-2012 Nissan Altima. Built to fit today's smaller, tighter-fitting engine compartments, it's engineered to resist electrochemical degradation — a leading cause of hose failure.
Caution: do not use for fuel or oil transfer applications. GATES recommends replacing the hose clamps each time a new coolant hose is installed.
Interchange: 217413TA0A · F10619 · 13442
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
What vehicles does this GATES hvac heater hose fit?
It is a direct-fit replacement for the 2007-2012 Nissan Altima. Check the "Vehicles it fits" section to confirm the exact application for your vehicle.
Where does this hose install?
This molded hose is positioned to run from the coolant reservoir to the filler neck.
What is the hose made of?
It uses an EPDM tube, synthetic fiber knit reinforcement, and an EPDM cover, and it meets SAE 20R3 Type EC Class D-1 and D-2 specifications.
Can I use this hose for fuel or oil?
No. Gates cautions against using it for fuel or oil transfer applications. It is approved for coolant, water, air, and marine applications.
Do I need new hose clamps when installing it?
Gates recommends replacing the hose clamps each time a new coolant hose is installed to help ensure a secure, leak-free connection.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.